Dynamic Softening Mechanism and an Improved Unified Constitutive Model for an Al–Cu–Mn–Fe–Zr Alloy during Warm Deformation

Jun-Quan Wang,Yong-Cheng Lin,Yu-Liang Qiu,Jiang-Shan Zhu,Xu-Hao Zhu,Yi-Wei Xiao
DOI: https://doi.org/10.1002/adem.202100015
IF: 3.6
2021-02-26
Advanced Engineering Materials
Abstract:<p>Deformation behavior of an Al‐Cu‐Mn‐Fe‐Zr alloy is investigated by plane strain compression tests at a warm deformation region. The flow stress first increases and then keeps steady, and the flow stress increases with reducing temperature or raising strain rate. However, the influence of strain rate on flow stress is weak at 100 °C and 150 °C. The DRV mechanism is the dominant mechanism to balance the working hardening, and a larger number of dislocations are consumed at low strain rates. So, the deformed grains are difficult to reach the critical strain for dynamic recrystallization (DRX). When the strain rate is relatively high, the critical strain can be reached in a short time, which promotes the process of DRX. In addition, an improved unified constitutive model is built based on the evolution of dislocation density. The predicted flow stresses are in a close agreement with the measured results, proving that the built model can nicely reproduce the flow behavior.</p><p>This article is protected by copyright. All rights reserved.</p>
materials science, multidisciplinary
What problem does this paper attempt to address?