Abstract:Revamping of the atmospheric absorption section in a urea plant reduces the gaseous emissions in the low pressure section, reduces raw materials consumption and increases production. So the economic benefits are increased. 1. General The urea plant of Hebei Cangzhou Dahua Group Co., Ltd. is a large-sized urea production plant with capacity of 1620 mtpd, imported in 1973 and using CO2 stripping process. In the original design, the off-gas from the low-pressure (LP) section is directly vented. Via a technical revamp of the plant in 1988, the LP section is provided with an atmospheric absorption section, which can absorb the off-gas from the LP section and the hydrolysis section at atmospheric pressure. After the plant modifications were implemented and put into service, the plant had a lot of technical problems, such as much liquid in the vent pipe, poor performance in scrubbing and absorption. Additionally after increasing the plant load the incremental vent flows of the LP and hydrolysis sections resulted in higher energy consumption figures. To improve the absorption performance of the atmospheric absorption section, reduce the consumption figures and the amount of off-gas vented, and to increase economic and environmental benefits, the urea plant was again technically revamped in 2011: The atmospheric absorption section was upgraded as the LP one. As a result, the said problems have been successfully solved. 2. Production before Revamp The atmospheric absorption section of the urea plant consists of the atmospheric absorption column (303E), the atmospheric absorption column cooler (304C) and the atmospheric absorption feed pump (705J). The diluted aqueous ammonia from the aqueous ammonia tank (701F) is sent by 705J to the top of 303E, and flows through the packed bed to absorb the ammonia in gas phase from the LP and hydrolysis sections; the absorption solution drained from the bottom of 303E is cooled by 304C and then send back to the aqueous ammonia tank; the off-gas in the vent pipe at the top of 303E is sent to the vent stack for venting. For the process flow diagram see Figure 1.

Technical Innovations on Ammonia Stripping Urea Plant

Equipment Maintenance and Intermittently Prilling Method for Urea Plant during Operation in Low load

Problems in ethyl benzene/styrene fractionator and countermeasures

Recent Development in Ammonia Stripping Process for Industrial Wastewater Treatment

Ammonia nitrogen removal and recovery from acetylene purification wastewater by air stripping

Deep Purification of Low-Strength Ammonium-Containing Wastewater with ANRE Process

Treatment Technologies of Ammonia-nitrogen Containing Wastewater From Villages and Their Application

Treatment Technologies of High Concentration Ammonia Nitrogen Wastewater and Their Research and Application Status

Revamp of Atmospheric Absorption Section of Urea Plant

Refrigeration capacity equilibrium and energy-saving revamping of liquid nitrogen washing unit in ammonia synthesis plant

Ammonia Production Plants—A Review

Performance of ANAMMOX-EGSB Reactor

Optimization for Operating Conditions for Synthetic Ammonia System in Medium and Small Scale Nitrogen Fertilizer Plant

Corrosion and Control for Urea Reactor in Urea Plant by Modified CO2 Stripping Method

Study of Technology of Urea Pyrolysis and Hydrolysis in Thermal Power Plant

Technical and Economical Analysis of a Novel Rotary Air Preheater System

Ammonia Removal from Wastewater of Different Sources and Recent Development in Ammonia Stripping

Process Design of Ammonia Separation for Nitrification Control in Aeration Basins at an IKORC’s Oily Wastewater Treatment Unit

Treatment of High Concentrated Ammonia-Nitrogen Wastewater in Coal Gasification Process by Air Stripping

Study on two-stage air-recirculation ammonia stripping process for membrane concentrate in livestock and poultry breeding

Recent technological developments in post combustion CO2 capture amine scrubbing process in commercial plants