Abstract:Controlling current at critical conduction mode (CRM) is an effective way to achieve zero voltage switching (ZVS) of switches for inverters. However, the higher reverse inductor current and fixed deadtime in fully digital soft-switching control, such as reverse current boundary-based (RCB-based) schemes, lead to higher rms inductor current and higher power losses. Besides, the digital control frequency for CRM-based inverters is not well designed, resulting in the contradiction between high performance and high digital calculation burden. Therefore, this article proposes a fully digital soft-switching control based on the variable <sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">off</small> -time and deadtime with an optimized designed digital control frequency. First, the variable <sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">off</small> -time and deadtime design guidelines are addressed with the established mathematical model of the CRM-based inverter. Then, the power losses of the inverter with different digital control frequencies and control schemes are quantitatively analyzed and compared. Finally, a 1 kW single-phase three-level neutral-point-clamped grid-tied inverter was built. Experimental results show that the proposed scheme can achieve the ZVS turn- <sc xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">on</small> of switches without additional components, and the maximum efficiency is 98.3%. Compared with the RCB-based scheme, the proposed method achieves higher efficiency with the same hardware cost.

A Small-Sized High-Precision Digital Closed-Loop Modulation Method for Dead-Time Compensation for Flying Capacitor Three-Level Inverters

Dead-time Effects Analysis and Elimination for Voltage Source Inverter

A Short-Circuit Fault-Tolerant Strategy for Three-Phase Four-Wire Flying Capacitor Three-Level Inverters

Single-Phase Inverter Deadbeat Control with One-Carrier-Period Lag

Analysis and compensation of dead-time effect in voltage source inverters considering parasitic capacitance and ripple current

Improved Three-Vector Based Dead-Beat Model Predictive Direct Power Control Strategy for Grid-Connected Inverters.

Capacitor Voltage Balancing Algorithm with Redundant Level Modulation for a Five Level Converter with Reduced Device Count

Implementation of DSP-based Three-Level Inverter with Dead Time Compensation

Analysis and compensation of dead-time effect considering parasitic capacitance and ripple current

Voltage Jump Suppression and Capacitor Voltage Fluctuation Analysis for a Four-Level Hybrid Flying Capacitor T-Type Converter

A Simple Modulation and Capacitor Voltage Balancing Method for Four-Level Single Flying Capacitor Converters

Modeling and Implementation of Optimal Asymmetric Variable Dead-Time Setting for SiC MOSFET-Based Three-Phase Two-Level Inverters

Dead-time compensation and single-loop control strategy for ground power unit

Variable OFF-Time and Deadtime Scheme With Optimized Control Frequency for Soft-Switching Single-Phase Inverters

A Bidirectional Three-Level Converter Control With Shared Control Circuit and Single-Point Sensing for Flying Capacitor Balance

Duty-Cycle-Regulation Based Pwm Control of Five-Level Flying-Capacitor Inverter

New Digital Control Method for Improving Dynamic Performance of a Quasi-Resonant Flyback Converter

DUTY-CYCLE-REGULATION BASED PWM CONTROL OF FLYING-CAPACITOR FIVE-LEVEL INVERTER

A New Modulation Method for a Five-Level Hybrid-Clamped Inverter with Reduced Flying Capacitor Size

Digitally controlled UPS inverter with dead time and output current compensation

A Novel Pwm Method for Stacked Flying Capacitor Inverter