Abstract:Heat transfer enhancement by tandem self-oscillating inverted flags was investigated for channel flow. An isolated flag was selected as the benchmark. The highly unsteady flapping motion of the inverted flag was captured using a high-speed camera and identified by the structure boundary detection algorithm. The resultant temperature fields were determined by temperature sensitive paint measurement. Three dynamic regimes were observed for the isolated inverted flag: biased, flapping, and deflected modes. The results show that the self-oscillating inverted flag in the flapping mode exhibited the most energetic motion, with a maximum amplitude of 1.75 times of the flag length and a Strouhal number 0.17. This significantly promoted heat removal from the heated wall, with a considerable local Nusselt number ratio exceeding 1.5. Tandem flags flapped synchronously with the same frequency at a low Reynolds number and a close distance G* between two inverted flags, and the phase difference depended linearly on the separation distance. Increases in the separation distance and Reynolds number led to decoupling behavior. Local Nusselt number ratio peak regions were found behind both the front and rear flags, and the heat transfer performance behind the rear flag was superior to that behind the front flag. The global Nusselt number ratio was not sensitive to the separation distance and Reynolds number for tandem flag configurations. Increasing Reynolds number reduced the mechanical loss, so operating the tandem inverted flags' system at a high Reynolds number moderately improved the heat transfer efficiency. Published by AIP Publishing.

The heat transfer enhancement with a flag-shaped flexible wing

Heat Transfer Enhancement in a Poiseuille Channel Flow by Using Multiple Wall-Mounted Flexible Flags

Heat transfer and flow characteristics in a rectangular channel with combined delta winglet inserts

Numerical Investigation of Enhanced Heat Transfer in a Rectangular Channel with Winglets

Heat Transfer Enhancement of Turbulent Channel Flow Using Tandem Self-Oscillating Inverted Flags

Experimental Study on Heat Transfer in Ducts with Winglet Disturbances

Heat transfer enhancement mechanism of elliptical cylinder for minichannels with delta winglet longitudinal vortex generators

Numerical Study of Flow and Heat Transfer Enhancement by Using Delta Winglets in a Triangular Wavy Fin-and-Tube Heat Exchanger

Heat Transfer Augmentation and Flow Visualization With Delta Winglets in a Tube: A Numerical Approach

Heat Transfer and Flow Characteristics in a Circular Tube Fitted with Rectangular Winglet Vortex Generators

Numerical investigation of heat transfer using a novel punched vortex generator

Numerical simulation study of enhanced convective heat transfer in the tube based on winglet vortex generator

Experimental investigation of heat transfer and friction on ducts with winglet fins

Numerical analysis of flow resistance and heat transfer in a channel with delta winglets under laminar pulsating flow

Investigation of the effect of rectangular winglet angles on turbulent flow and heat transfer of water/Cu nanofluid in a three-dimensional channel

Enhancement of heat transfer performance of a channel flow using modified delta Winglet vortex generator

Enhancement of Laminar Flow Heat Transfer with Single/double-Inclined Ribs for Unilaterally-Heated Channel

Numerical study on the influence of wall temperature gradient on aerodynamic characteristics of low aspect ratio flying wing configuration

Vortex Dynamics and Heat Transfer Behind Self-Oscillating Inverted Flags of Various Lengths in Channel Flow

HEAT TRANSFER ENHANCEMENT IN A CHANNEL WITH LONGITUDINAL VORTEX GENERATORS AND FIELD SYNERGY PRINCIPLE ANALYSIS

Thermal performance augmentation of microchannel using curved rectangular winglet vortex generators having rectangular perforation