Abstract:An understanding of the origins of power loss in superconducting interconnects is essential for the energy efficiency and scalability of superconducting digital logic. At microwave frequencies, power dissipates in both the superconducting wires and the dielectric and these losses can be of comparable magnitude. We describe an approach to accurately disentangle such losses by exploiting their frequency dependence in a multimode transmission-line resonator. This is supported by the concept of a resonator geometric factor extracted from the Ansys High Frequency Structure Simulator ( hfss ), a commercial three-dimensional finite-element method (FEM) that we adopt for solving a superconductor interior. Using the technique, we have optimized a planarized fabrication process of reciprocal quantum logic (RQL) for the minimum interconnect loss at 4.2 K and gigahertz frequencies. The microstrip interconnects are composed of niobium ( Nb ) insulated by silicon dioxide ( SiO 2 ) made from a tetraethoxysilane (TEOS) precursor. Two process generations use damascene fabrication and the third one uses Cloisonné fabrication. For all three, SiO 2 exhibits a dielectric loss tangent tanδ=0.0012±0.0001 , independent of the Nb wire width over 0.25–4 μm . The intrinsic microwave resistance Rs of Nb varies with both the process and the wire width. For damascene fabrication, scanning transmission electron microscopy (STEM) and energy-dispersive x-ray spectroscopy (EDS) reveal that plasma oxidation and grain-growth orientation increase Rs above the Bardeen-Cooper-Schrieffer (BCS) resistance RBCS≈17μΩ at 10 GHz. For Cloisonné fabrication, we demonstrate Rs=13±1.4μΩ down to 0.25μm wire width, which is below RBCS and arguably the lowest microwave resistance reported for Nb at 4.2 K. https://doi.org/10.1103/PhysRevApplied.21.024056 © 2024 American Physical Society

Thin film metrology and microwave loss characterization of indium and aluminum/indium superconducting planar resonators

Materials loss measurements using superconducting microwave resonators

Microwave loss characterization using multi-mode superconducting resonators

Characterization of process-related interfacial dielectric loss in aluminum-on-silicon by resonator microwave measurements, materials analysis, and imaging

Loss mechanisms in superconducting thin film microwave resonators

High-Q trenched aluminum coplanar resonators with an ultrasonic edge microcutting for superconducting quantum devices

Loss Dependence on Geometry and Applied Power in Superconducting Coplanar Resonators

Low-loss α-tantalum coplanar waveguide resonators on silicon wafers: fabrication, characterization and surface modification

Determining interface dielectric losses in superconducting coplanar waveguide resonators

Mitigation of interfacial dielectric loss in aluminum-on-silicon superconducting qubits

Direct Measurement of Microwave Loss in Nb Films for Superconducting Qubits

Identification and Mitigation of Conducting Package Losses for Quantum Superconducting Devices

Tuning microwave losses in superconducting resonators

Disentangling superconductor and dielectric microwave losses in submicrometer / interconnects using a multimode microstrip resonator

Substrate and process dependent losses in superconducting thin film resonators

Demonstration of superconducting micromachined cavities

Comparison of dielectric loss in titanium nitride and aluminum superconducting resonators

Superconducting Microstrip Losses at Microwave and Sub-millimeter wavelengths

Geometric Scaling of Two-Level-System Loss in Superconducting Resonators

Annealing reduces Si$_3$N$_4$ microwave-frequency dielectric loss in superconducting resonators

Microwave loss and kinetic inductance of epitaxial TiN films