Abstract:Splitting droplets is becoming a major functional component in increasing number of droplet microfluidic applications, and there is an increasing interest in splitting droplets into two daughter droplets with different volumes. However, designing an asymmetric droplet splitter and predicting how a droplet splits in such designs is not trivial. In this study, numerical simulations were conducted to study droplet breakup in asymmetric T-junctions of square cross-sections having different pressure gradient ratios (i.e. T-junctions with outlet branches of different lengths). The goal of the simulation is to identify the conditions where a parent droplet breaks or does not break into two smaller droplets of different sizes (so called critical condition) and to identify the important fluid and microchannel parameters in this process. Four modes of droplet breakup (primary-, transition-, bubble-, and non-breakups) are identified and an empirical correlation is introduced that can predict the breakup/non-breakup of the droplet based on the parent droplet size and the capillary number. The simulation results are then compared with experimental data to verify its accuracy and the effect of fluids properties on the proposed correlation are studied. Two major asymmetric breakup mechanisms are determined, namely "breakup with permanent obstruction" and "unstable breakup". The numerical results show that the splitting ratio for the asymmetric breakup mechanisms depends on flow conditions and dwell time of the droplet at the junction prior to splitting. Finally, the results from two-dimensional and three-dimensional simulations were compared. It is shown that two-dimensional simulation may not accurately predict the breakup behavior for asymmetric droplet breakup and viscosity ration has a greater effect on the prediction critical condition.

Hydrodynamic characteristics of detachment length and flow mapping in T-junction circular microchannel

WATER-OIL FLOW IN SQUARE MICROCHANNELS WITH A CROSSED JUNCTION

EFFECTS OF INLET ARRANGEMENTS ON LIQUID-LIQUID FLOW PATTERNS IN CROSS-JUNCTION SQUARE MICROCHANNELS

Mixing Efficiency Analysis On Droplet Formation Process In Microchannels By Numerical Methods

Inner circulation flow characteristics of coalescence droplets in microchannel

Effect of fluid properties on intensification of heat transfer process in oil-water droplet flow in a T-shaped microchannel

Simultaneous influence of contact angle, capillary number, and contraction ratio on droplet dynamics in hydrophobic microchannel

Droplet behavior and its effects on flow characteristics in T-junction microchannels

Numerical and experimental investigation of dripping and jetting flow in a coaxial micro-channel

Dynamic mechanism of double emulsion droplets flowing through a microfluidic T-junction

Asymmetric branch selection and splitting of droplets in T-junction microchannels

Prediction of Microdroplet Breakup Regime in Asymmetric T-Junction Microchannels

A Comprehensive Study of Droplet Formation in a Capillary Embedded Step T-junction: from Squeezing to Jetting

Experimental and Numerical Study of Mixing Behavior Inside Droplets in Microchannels

Droplet formation in a microfluidic T-junction involving highly viscous fluid systems

A computational study on transition mechanism of dripping to jetting flow in a flow‐focusing geometry

CFD Simulation of Internal Flow and Mixing within Droplets in a T-Junction Microchannel

Hydrodynamics and Mass Transfer of Liquid-Liquid Two-Phase Flow in Circular Milli-Channels: Sizing-up Effect

CFD analysis of effects of surface wettability and flow rates on the interface evolution and droplet pinch-off mechanism in the cross-flow microfluidic systems

Determination of Interfacial Tension and Viscosity under Dripping Flow in a Step T-junction Microdevice

Correlations of droplet formation in T-junction microfluidic devices: from squeezing to dripping