Abstract:NHR200-II is a 200 MW nuclear heating reactor. The integrity of the fuel assembly should be ensured during the normal operations and design basis accidents. In the latter cases (e.g. earthquake), its deformation or damage should not prevent the insertion of control rods to shut down the reactor. Meanwhile, during the operating time, there are two aspects that attention should be paid, (i) the mechanical performance of internal core materials might be worsened by the increase of burnup and (ii) dynamic loads involving hydraulic erosion, flow-induced vibration might damage the assemblies. Therefore, the investigation of the dynamic characteristics of the fuel assembly with consideration of burnup effects is necessary. The fuel rod with pellets and cladding was approximated by the beam elements with a circular cross-section applied with calibrated material properties. Connector elements were used to replace the three-arc springs and dimples on the grid and thus simplify the geometry of the spacer grid. The agreements between the detailed and simplified models indicate the equivalence of these two methods. Then two simulations were performed to evaluate the dynamic characteristics of NHR200-II fuel assembly at the beginning of life. The modal simulation of the fuel bundle and channel suggests that the channel could be assumed stationary to the fuel bundle during the dynamic analysis. The seismic simulation conducted in the specific boundary conditions indicates that the integrity of spacer grids can be guaranteed and there was no buckling of the gird. No permanent deformation of the channel was observed, and its relative displacements were sufficiently small to ensure the insertion of control rods. Finally, burnup effects on the structural behavior of the fuel rod are discussed. The initial conditions of NHR200-II fuel assembly and its material properties at different burnup times are provided by referring to two irradiated tests. Various sensitivity analyses had been conducted to evaluate the effects of material properties and pellet-cladding interaction on the resulting failure limit and stiffness of the fuel rod.

Study on In-Service Inspection of Nuclear Fuel Assembly Failure Using Ultrasonic Plate Wave

Ultrasonic Guided Wave-Based Circumferential Scanning of Plates Using a Synthetic Aperture Focusing Technique

Proposal and Validation of a Diagnosis Method of Fuel Failures in Pressurized Water Reactor Nuclear Power Plants

Welding defect detection in nuclear power plant spent fuel pool panels based on alternating current field measurement: experimental and finite element analysis

The simulation design of eddy current inspection on the control rod of nuclear power plant

In-core sipping method for the identification of failed fuel assemblies

Tensile Failure Analysis of U3Si2-Al Fuel Plate

Numerical Study of Coupled Fluid and Solid Wave Propagation Related to the Cladding Failure of a Nuclear Fuel Rod

Nondestructive evaluation of nuclear spent fuel dry cask structures using non-contact ACT-SLDV Lamb wave method

Research on Intelligent Detection Technology of Surface Defects of Nuclear Fuel Rods Based on Machine Vision

Structural health monitoring of stainless-steel nuclear fuel storage canister using acoustic emission

Thermal-fluid-structure Coupling Analysis for Plate-Type Fuel Assembly under Irradiation. Part-I Numerical Methodology

STUDY ON THE DEGRADATION BEHAVIORS OF ANNULAR FUEL UNDER SEVERE ACCIDENT

Application of advanced ultrasonic testing methods to Dissimilar Metal Welds -- Comparison of simulated and experimental results

Combining ultrasonic guided wave and low-frequency electromagnetic technology for defect detection in high-temperature Cr–Ni alloy furnace tubes

Simulation of Dynamic Characteristics of NHR200-II Fuel Assembly

Containment Liner Plate Void Defect Detection Technique Using Phased Array Ultrasonic Testing and Acoustic Resonance Method

Experimental and Numerical Study on the Oxidation and Melting Behaviors of Annular Fuel Rod under High Temperature Steam Condition

Steady-State Performance Analysis of a Dual-Cladding Design for Accident Tolerance Fuel

Partial Engineering Validate Test Investigation of New U_3Si_2-Al Fuel Subassembly

Numerical Simulation Investigations on the Flow Induced Vibration of a Nuclear Fuel Rod with Relaxed Clamping Structures