Abstract:Monitoring geotechnical structures and providing real-time early warning is a key measure to mitigate the impacts of disasters (slope slip, subsidence, dam deformation, bridge settlement, etc.). The fiber Bragg grating (FBG) flexible sensor, developed by the combination of flexible material and an FBG sensor, is widely used in geotechnical engineering health monitoring due to its excellent performance. The flexible sensor can perform regional and quasi-distributed measurements of the displacement field of the measured structure, and accurately reflect the operating state of the engineering structure. However, in practical engineering applications, factors such as the strain-transfer rate between the flexible substrate and sensing points, the displacement reconstruction algorithm, and the arrangement interval of the sensing points can cause measurement error, which, in turn, leads to a decrease in the displacement-measurement accuracy. In this paper, the following analysis is performed by means of theoretical derivation and model establishment. The influence of the length, width, and thickness of the cemented layer, the shear modulus of the flexible substrate, and the radius of the groove on the strain-transfer rate were analyzed, and the referential parameters were determined. The displacement reconstruction algorithm is essentially a recursive algorithm, which inevitably introduces cumulative error; the relationship between the layout interval of the sensing points and the measurement error is discussed. Considering the fabrication cost of the sensor and the allowable range of error, a sensing-point-layout interval of 100 mm was chosen. The feasibility and effectiveness of the simulation theory were verified by carrying out deformation-sensing experiments on the developed FBG flexible sensor. The research results can theoretically guide the packaging and fabrication of the FBG flexible sensor, thereby improving the measurement accuracy of the flexible sensor for the measured structure.

Enhanced PDMS-embedded FBG devices for displacement sensing

Structural Instability-Enabled Mechanical Sensors Using Fiber Bragg Grating

Highly Sensitive Displacement Sensor Based on Composite Interference Established Within a Balloon-Shaped Bent Multimode Fiber Structure.

Simultaneous Measurement of Displacement and Temperature Based on a Balloon-Shaped Bent SMF Structure Incorporating an LPG

Highly Sensitive Lateral Deformable Optical MEMS Displacement Sensor: Anomalous Diffraction Studied by Rigorous Coupled-Wave Analysis.

Multimode-interference-effect-based all-fiber displacement sensing system for an orthopedic Ilizarov apparatus device.

Simultaneous Measurement of Displacement and Temperature Based on Two Cascaded Balloon-Like Bent Fibre Structures

Fiber-Bragg-Grating-Based Displacement Sensors: Review of Recent Advances

A Fiber Bragg Grating Sensor for Positive and Negative Displacement Measurement

An FBG Displacement Sensor in Deformation Monitoring of Subway Floating Slab

Measurement-Error Analysis of Fiber Bragg Grating Flexible Sensor for Displacement-Field Monitoring of Geotechnical Engineering

Simultaneous measurement of dynamic displacement and strain in a single fiber using coarse wavelength-division multiplexing and fiber Bragg-grating filter-based sensing system

Polymer-capped fiber Fabry-Perot interferometer for large range displacement sensing

Study of Fiber Grating Displacement Sensor

Dynamic Sensing Performance of a Point-Wise Fiber Bragg Grating Displacement Measurement System Integrated in an Active Structural Control System

Fiber Bragg Grating Displacement Sensor with High Abrasion Resistance for a Steel Spring Floating Slab Damping Track

Fiber Bragg Gratings Sensor Strain–Optic Behavior with Different Polymeric Coatings Subjected to Transverse Strain

Investigations on thermal and mechanical characteristics of PDMS embedded FBG sensors for wearable sensing applications

Design and Optimization of FBG Implantable Flexible Morphological Sensor to Realize the Intellisense for Displacement

A New Flexible FBG Sensing Beam for Measuring Dynamic Lateral Displacements of Soil in a Shaking Table Test

Fiber Optic Displacement Monitoring in Laboratory Physical Model Testing