Abstract:Cost-effective and environmentally friendly sorbents were created for capturing CO 2 by incorporating monoethanolamine (MEA) and tetraethylenepentamine (TEPA) onto a microporous activated carbon (AC) material. The application of a KOH reagent enhanced the surface area and pore volume of the carbon material. The BET, SEM, EDX, and FTIR techniques were employed to analyze the structural and surface properties of the developed samples. Raw AC possessed the highest surface area and largest micropore volume equal to 786 m 2 /g and 0.33 cm 3 /g, respectively. The amine impregnation increased the nitrogen content of the carbon material, but it also significantly reduced the BET surface area and total pore volume, which are primarily responsible for physically adsorbing CO 2 towards ACs. The CO 2 adsorption performance of the raw and impregnated ACs was experimentally evaluated using thermogravimetric analysis (TGA) at different adsorption temperatures (25 and 50 °C) and CO 2 concentrations (10 and 90 vol.%). The findings demonstrated that the raw AC exhibited the highest capacity for CO 2 adsorption. Specifically, at a temperature of 25 °C and pressure of 1 bar (10 vol.% CO 2 , N 2 balance), the raw AC achieved an uptake of 1.2 mmol/g, which was 60.3% and 79.3% higher compared to the CO 2 uptake of MEA-AC (0.5 mmol/g) and TEPA-AC (0.3 mmol/g), respectively. It is surprising that the combined uptake of CO 2 + H 2 O increased by 12.5 and 23.4 wt.% (equivalent to 7 and 13 mmol/g) for MEA-AC and TEPA-AC, respectively, when humid flue gas was taken into account under the conditions of 50 °C, with 10 vol.% CO 2 , 4 vol.% H 2 O, and N 2 balance. These results indicate that the presence of H 2 O facilitates the chemisorption of CO 2 by the novel and highly promising carbon-based sorbent prepared in this study, leading to an increased capacity for adsorbing CO 2 under water vapor containing flue gases.

The effect of the active carbonyl groups and residual acid on the ammonia adsorption over the acid-modified activated carbon

Effect of Nitric Acid Pretreatment on the Properties of Activated Carbon and Supported Palladium Catalysts

Title : Effect of Na + impregnated activated carbon on the adsorption of NH 4 +-N from aqueous solution

Efficient Adsorption of Ammonia by Surface-Modified Activated Carbon Fiber Mesh

Enhancement of CO2 Adsorption on High Surface Area Activated Carbon Modified by N2, H2 and Ammonia

Adsorption of ammonia on activated carbon from aqueous solutions

Adsorption–Reduction Behavior of Co(NH3) on Activated Carbon

Performance of CO2 Adsorption on Modified Activated Carbons Derived from Okara Powder Waste: Impacts of Ammonia Impregnation

Nitrogen Doping of Activated Carbon Loading Fe2O3 and Activity in Carbon-Nitric Oxide Reaction

Impact of anion adsorption on the determination of the basic site concentration of activated carbons by a reaction with different acids

Functionalized Cross-Linking Mechanism of Biochar "Adsorption-Reaction Microunit" on the Promotion of New Ammonia-Based Co2 Capture

Effects of acid modification on the structure and adsorption NH4+-N properties of biochar

EFFECTS OF MICROPORE AND FUNCTIONAL GROUPS OF ACTIVATED CARBON ON ADSORPTION BEHAVIOR OF FORMALDEHYDE

Research on Surface Properties of Modified Activated Carbon Fiber and Its Mercury Adsorption Performance

Functionalized cross-linking mechanism of biochar "adsorption-reaction microunit" on the promotion of new ammonia-based CO 2 capture

Adsorption-enrichment Characterization of CO2 and Dynamic Retention of Free NH3 in Functionalized Biochar with H2O/NH3·H2O Activation for Promotion of New Ammonia-Based Carbon Capture

CO2 adsorption on chemically modified activated carbon

Activated Carbon Fiber Composites for Gas Phase Ammonia Adsorption

A study on and adsorption mechanism of ammonium nitrogen by modified corn straw biochar

The effect of humidity on the enhanced CO2 adsorption of amine-functionalized microporous activated carbon

A review on surface modification of activated carbon for carbon dioxide adsorption