Prediction of Microstructure Evolution in Ball Mill Liner Forging Process

Hongchao Ji,Wei Liu,Weimin Liu,Xiaomin Huang,Changzhe Song,Shengqiang Liu

DOI: https://doi.org/10.1002/srin.202400479

IF: 2.1258

2024-09-11

steel research international

Abstract:The material model of Mn–Cr–Ni–Mo steel was established. The hot forging process of liner was numerically simulated. The effect of the interaction of process parameters on the microstructure uniformity of the ball mill liner was studied by using the response surface model. And the relevant experiments are used to verify. The liner is affixed to the inner side of the ball mill cylinder to protect the cylinder. Through isothermal compression experiments, Arrhenius constitutive models, peak strain models, critical strain models, dynamic recrystallization dynamic models, and grain size models suitable for the forging process of Mn–Cr–Ni–Mo steel used in ball mill liners were established. By utilizing Deform software, a 3D thermo‐force‐structure coupling model for the hot forging process of ball mill liners was constructed, and the volume fraction of dynamic recrystallization and average grain size during forging was predicted. The response surface model was employed to investigate how process parameters interacted with each other and affected microstructure uniformity in ball mill liners. After optimization, the optimal parameters were determined: initial forging temperature at 1200 °C, forging speed at 30 mm s−1, and friction coefficient at 0.3. Subsequently, a hot forging experiment on ball mill liners was conducted using these optimized parameters; samples were analyzed through backscattered electron diffraction device experiments and microscopic tissue observations. Results demonstrated that microstructural changes observed during actual forging processes aligned with numerical simulation results—thus verifying both the accuracy of the Mn–Cr–Ni–Mo steel material model and numerical simulation method.

metallurgy & metallurgical engineering