Abstract:The surge in air pollution and respiratory diseases across the globe has spurred significant interest in the development of flexible gas sensors prepared by low-cost and scalable fabrication methods. However, the limited breathability in the commonly used substrate materials reduces the exchange of air and moisture to result in irritation and a low level of comfort. This study presents the design and demonstration of a breathable, flexible, and highly sensitive NO2 gas sensor based on the silver (Ag)-decorated laser-induced graphene (LIG) foam. The scalable laser direct writing transforms the self-assembled block copolymer and resin mixture with different mass ratios into highly porous LIG with varying pore sizes. Decoration of Ag nanoparticles on the porous LIG further increases the specific surface area and conductivity to result in a highly sensitive and selective composite to detect nitrogen oxides. The as-fabricated Ag/LIG gas sensor on a flexible polyethylene substrate exhibits a large response of −12‰, a fast response/recovery of 40/291 s, and a low detection limit of a few parts per billion at room temperature. Integrating the Ag/LIG composite on diverse fabric substrates further results in breathable gas sensors and intelligent clothing, which allows permeation of air and moisture to provide long-term practical use with an improved level of comfort.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.2c02061.Design and geometric parameters of the gas sensor; optical images of the F127/resols and corresponding LIG patterns (insets) on varying substrates; deconvoluted C 1s of the LIG prepared by the 3:2 F127/resols; SEM image of Ag-coated LIG (3:2 mass ratio) and the corresponding EDS spectrum; optical image of the four-point probe and the resulting sheet resistance measurements; current–voltage (I–V) curves of the LIG with three different F127/resol mass ratios; typical response curve of the pristine LIG gas sensor with the largest pore size to 1 ppm NO2; schematic diagram showing the sensing mechanism of the Ag/LIG composite to NO2; analysis of the peak intensity ratios of the D and 2D to G obtained from the Raman spectra; XPS analysis of the Ag 3d intensity in the Ag/LIG composite; optical images of the Ag/LIG composite on knitted fabric, Kevlar fiber, and non-woven fabric to demonstrate the large-scale production; dynamic response curves of a Ag/LIG-based gas sensor on three different fabric substrates upon exposure to NO2 ranging from 0.5 to 2.5 ppm; and comparison in the weight change between the bottles covered by the knitted fabric and that with three different Ag/LIG composites (PDF)This article has not yet been cited by other publications.

High sensitivity low-temperature ethanol and acetone gas sensors based on silver/titanium oxide decorated laser-induced graphene

Patterned Laser-Induced Graphene Enabling a High-Performance Gas Sensing Split-Ring Resonator

Room temperature sensing of volatile organic compounds using hybrid SnO nanoflower and Laser-Induced Graphitic carbon devices

Room Temperature Sensing of Volatile Organic Compounds Using Hybrid Layered SnO Mesoflowers and Laser-Induced Graphitic Carbon Devices

Investigation of Laser-Induced Graphene (LIG) on a Flexible Substrate and Its Functionalization by Metal Doping for Gas-Sensing Applications

Flexible Impedimetric Electronic Nose for High-Accurate Determination of Individual Volatile Organic Compounds by Tuning the Graphene Sensitive Properties

In situ laser-assisted synthesis and patterning of graphene foam composites as a flexible gas sensing platform

Novel gas sensing platform based on a stretchable laser-induced graphene pattern with self-heating capabilities

Intrinsically Breathable and Flexible NO2 Gas Sensors Produced by Laser Direct Writing of Self-Assembled Block Copolymers.

Alcohol Recognition by Flexible, Transparent and Highly Sensitive Graphene-Based Thin-Film Sensors

A Room Temperature VOCs Gas Sensor Based on a Layer by Layer Multi-Walled Carbon Nanotubes/Poly-ethylene Glycol Composite

Development of an NO2 Gas Sensor Based on Laser-Induced Graphene Operating at Room Temperature

Intrinsically Breathable and Flexible NO 2 Gas Sensors Produced by Laser Direct Writing of Self-Assembled Block Copolymers

Graphene/poly (methyl methacrylate) electrochemical impedance-transduced chemiresistor for detection of volatile organic compounds in aqueous medium

Graphene Oxide Thin Films for Detection and Quantification of Industrially Relevant Alcohols and Acetic Acid

Assembling a high-performance acetone sensor based on MOFs-derived porous bi-phase -/-Fe<sub>2</sub>O<sub>3</sub> nanoparticles combined with Ti<sub>3</sub>C<sub>2</sub>T<sub>x</sub> nanosheets

Photothermal-assisted for ultrafast response acetone sensing with ZIF-90/GO coated microfiber long period gratings

Ag/SnO2/graphene Ternary Nanocomposites and Their Sensing Properties to Volatile Organic Compounds

Graphene Nanocomposite Ink Coated Laser Transformed Flexible Electrodes for Selective Dopamine Detection and Immunosensing

Femtosecond Laser-Induced Graphene for Temperature and Ultrasensitive Flexible Strain Sensing

An effective formaldehyde gas sensor based on oxygen-rich three-dimensional graphene