Abstract:The discrete element models of rock cutting were established, and the reliability of the model was verified in comparison with the scratch test results and finite element simulation results. This study simulated the process of rock cutting under an impact load, and the influences of the static and impact loads on the cutting force and rock breaking were analyzed. A methodology is presented to increase drilling efficiency by selecting the suitable impact properties according to different drilling parameters.Combining well‐drilling hammers with polycrystalline diamond compact bits to break rock under cutting load and impact load is an effective way to improve drilling efficiency. Although impact load can enhance the cutting efficiency of the cutter, excessive impact can also cause the cutter to be subjected to additional vibrations, which can decrease its working life. Knowledge of laws governing the changes in the cutting force of the cutter under impact load is essential for the design and selection of well‐drilling hammers. Based on rock scratch tests and finite element rock cutting model, a discrete element modeling (DEM) rock cutting model was established to analyze the rock breaking and cutting force. Then, the material parameters of rock samples were determined, and the simulation parameters were corrected. Finally, a DEM rock cutting model under an impact load was established. The results showed that when there was an obvious difference between the average cutting force and mean peak cutting force, which corresponded to the rock‐breaking transition from ductile to brittle, with introduction of the impact load leading to an earlier transition. The cutting force variance was proportional to the impact amplitude, and the increase in the cutting force variance became more obvious when the static load exceeded the critical transition weight. When the ratio of the impact amplitude to the static load was greater than 50%, the mean and variance of the cutting force increased rapidly. Under the same impact amplitude, the impact frequency had little effect on the average cutting force, but a higher frequency could significantly reduce the variance of the cutting force under a high static load (i.e., it could alleviate the fluctuation of the cutting force). These results provide a reference for the selection of well‐drilling hammers and optimization of the impact load.

Investigation of Combined Rock-Breaking Ability of Sawblade and Conical Pick

The rock damage mechanism of combined rock breaking with saw blade and conical pick

Research on Numerical Simulation of Rock Breaking Using Tbm Disc Cutters Based on Udec Method

Study conical pick cutting performance and fatigue life in breaking rock plate process with numerical simulation

Numerical Simulation of Conical Pick Cutting Arc Rock Plate Fracture Based on ANSYS/LS-DYNA

Mechanical responses and fracture mechanism of rock with different free surfaces under the chisel pick cutting

The mechanism and performance of rock breakage by undercutting disc cutter with advanced slotting

Specific energy analysis of rock cutting based on fracture mechanics: A case study using a conical pick on sandstone

3D numerical simulation study of rock breaking of the wavy PDC cutter and field verification

Experimental Investigation of Rock Cuttability Based on Rock Indentation Tests by a Conical Pick

Investigating the cutting force of disc cutter in multi-cutter rotary cutting of sandstone: Simulations and experiments

Experimental studies on the characteristics of chisel picks in coal cutting for bucket wheel excavators

Microwave-Assisted Linear Cutting of Sandstone with a Conical Pick: Experimental Study

Discrete Element Modeling of the Effects of Cutting Parameters and Rock Properties on Rock Fragmentation

A dynamic analysis of a conical pick during rock-cutting process based on the smooth finite element method

Comparative Study of the Rock-breaking Mechanism of a Disc Cutter and Wedge Tooth Cutter by Discrete Element Modelling

Research and analysis of rock breaking mechanical model of single-roller PDC compound bit

Edge Chipping of Rock: an Experimental Study

Research on discrete element modeling and numerical simulation of cutting rock behavior under impact load

Discrete element modeling and simulation study on cutting rock behavior under spring-mass-damper system loading

Experimental and Numerical Investigations on Rock Breaking of TBM Disc Cutter Based on a Novel Platform with Rotational Cutting