Abstract:Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering, Ahead of Print. The conventional contour method (CM) needs multiple cuts at different locations to obtain the multiple components of residual stress in a specimen. To improve the convectional CM, an extended CM was proposed in the present study to determine the multiple stress components in a thick butt-welded joint without cutting at different locations. First, the longitudinal residual stress in the specimen was measured with the CM, then a thin slice was cut from the after-cut specimen, and the remaining transverse stress in the slice was measured with the X-ray diffraction method and the released transverse stress of the slice was constructed by the finite element analysis (FEA), and finally, the transverse stress on the same cross-section was obtained by the superposition of the remaining and the released transverse stresses on the slice. A two-cut CM was also carried out to get the transverse stress along the weld line center. The stress distribution characteristics of the specimen and the release extent of the transverse stress in the slice were discussed. The results show that the extended CM can evaluate the original biaxial residual stresses on a cross-section without multiple cuts at different locations. The transverse stress distribution trend obtained by the extended CM is close to that from the two-cut CM. Without considering the compressive stress induced by ultrasonic impact treatment, the longitudinal stress in the weld region is tensile with a maximum value of 550 MPa and the transverse stress at the weld line center is self-equilibrating with a maximum value reaching 552 MPa. Two peaks of tensile longitudinal and transverse stress appear at a certain distance beneath the top and bottom surfaces. When cutting a thin slice with a thickness of 5 mm along the transverse direction from the after-cut specimen, over 82% of the original tensile transverse stresses are retained in the slice.

Stress biaxiality-based residual stress assessment in welded T-joints using the blind-hole method

Assessing the Residual Stresses in Dissimilar Welded Joint: Depth-Sensing Indentation Testing and Numerical Simulation

Using Iterative Correction to Improve the Accuracy of the Blind-Hole Welding Residual Stress Test

Measurements of residual stresses in a welded orthotropic steel deck by the hole-drilling method considering stress biaxiality

Experimental Evaluation of Stress Concentration Factor of Welded Steel Bridge T-Joints

A method for stress concentration factor determination of welded steel bridge T-joints under moving load

Reliability-based Assessment of Steel Bridge Deck Using a Mesh-Insensitive Structural Stress Method

Experimental investigation and numerical simulation on welding residual stress of innovative double-side welded rib-to-deck joints of orthotropic steel decks

Hot Spot Stress Approach For Fatigue Life Assessment In Welded Bridge Connections Using Monitoring Data And Fem Analysis

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

PWHT influence on welding residual stress in 45 mm bridge steel butt-welded joint

Mechanism of biaxial pre-stress method on welding residual stress and hot cracks controlling

Residual Stress Redistribution Analysis in the Repair Welding of AA6082-T6 Aluminum Alloy Joints: Experiment and Simulation

Numerical Simulation and Measurement of Welding Residual Stresses in Orthotropic Steel Decks Stiffened with U-Shaped Ribs

FE analysis of residual stress and welding deformation of a low-alloy UHS quenched steel fillet joint

Effect of welding residual stress on the performance of CFST tubular joints

A physically consistent 2D residual stress model for approximating 3D effects in welding

Three-dimensional finite element analysis on welding residual stresses of construction steel

Investigation on residual stress of EQ56 high strength steel butt weld

Evaluation of multiple residual stress components in a thick welded joint using extended contour method

Measuremnet of Welding Residual Stress of T92 Steel Tube Based on Blind-hole Method