Abstract:Catalytic decomposition of benzene was studied by using oxides of vanadium and tungsten supported on titanium oxide (TiO2) catalysts for effective reduction of emissions of toxic organic compounds from waste incineration. Experiments were conducted to evaluate the effects of the catalyst's composition, and operating conditions on benzene decomposition, and the relationship between molecular structures of catalysts and their activity was also investigated through replacing the conventional TiO2 catalyst support by nano-sized TiO2. Trace levels (1 and 10 ppm) of gaseous benzene were catalytically decomposed in a fixed-bed catalytic reactor with monolithic oxides of vanadium and tungsten supported on titanium oxide (V2O5-WO3/TiO2) catalysts under conditions simulating the cooling of waste incineration flue gas. On-line monitoring of trace benzene concentrations before and after the catalyst was achieved by means of resonance enhanced multiphoton ionization-time of flight mass spectrometry (REMPI-TOFMS). Catalysts were characterized by nitrogen adsorption, X-ray diffraction, energy dispersive X-ray spectroscopy, temperature-programmed reduction, and Raman spectroscopy. The effects of several parameters, including catalyst operating temperature, space velocity (SV) and initial benzene concentration, on catalytic oxidation of benzene were investigated. Experimental results indicate that reduction of the initial benzene concentration from 10 to 1 ppm either enhances or decreases the catalytic removal efficiency depending on the adsorption capability as well as the oxidation ability of the catalyst tested. The catalytic activity for benzene oxidation not simply relies on the vanadium content of the catalyst; the molecular structure of vanadium oxide, which is known to be influenced by both vanadium oxide loading and the type of support, is very important. Nano-sized TiO2 supported vanadium oxide catalyst (VWNT) with lowest V loading (0.75 wt.%) provides higher catalytic activity than those of the catalysts with higher V contents (1.31 and 2.92 wt.%) but supported by conventional TiO2 (VWT1 and VWT2). The relatively higher catalytic activity of VWNT may be attributed to: (a) the presence of monomeric VOx species, with one terminal V=O bond as indicated by Raman spectra; (b) fewer impurities confounding active catalytic constituents (V, W and Ti); (c) pure anatase phase of TiO2 rather than a mixture phase of anatase and rutile servicing as catalyst support besides its nano-scale particle size; (d) larger specific surface area, smaller average pore diameter, and narrower pore size distribution contribute higher adsorption ability for benzene. No obvious competition effect between NOx removal and benzene oxidation was observed in this study. Reaction rate constants and activation energies for benzene catalytic oxidation tested by the catalysts were calculated. Lower activation energy obtained from VWNT than those of the two catalysts further confirming the higher catalytic activity of VWNT. Published by Elsevier B.V.

Producing a monolithic catalyst for the catalytic oxidization of dioxins by comparing extrusion and coating methods

Highly Catalytic Performance for the Selective C-H Bond Oxidation of P-Chlorotoluene over Co, Cr Co-Doped OMS-2 Catalyst

Catalytic Degradation of 1,2-Chlorobenzene and Dioxins Coupled by Kinds of Methods

A Facile Route for Spraying Preparation of Pt/TiO2 Monolithic Catalysts Toward VOCs Combustion

Catalytic Combustion of VOCs on Pt/CuMnCe and Pt/CeY Honeycomb Monolithic Catalysts

Study on the Decomposition of Trace Benzene over V2O5–WO3/TiO2-based Catalysts in Simulated Flue Gas

Mofs-derived CuCeOx Supported on H-zeolite Socony Mobile-5 for Catalytic Oxidation of 1,2-Dichlorobenzene

Promoting Effect of FeOx Addition on the Mechanochemically Prepared Vanadium-Based Catalyst for Real PCDD/Fs Removal and Mechanism Insight

Elucidating the nature role of acid etching on the CoMnO x catalyst with outstanding performance for the catalytic combustion of o-dichlorobenzene

Ru-based monolithic catalysts for the catalytic oxidation of chlorinated volatile organic compounds

Catalytic Oxidation of PCDD/F on a V2O5-WO3/TiO2 Catalyst: Effect of Chlorinated Benzenes and Chlorinated Phenols

Catalytic oxidation of PCDD/F on a V2O5-WO3/TiO2 catalyst: Effect of chlorinated benzenes and chlorinated phenols.

Effect of multi-pollutant on the catalytic oxidation of dichloromethane over RuO2-WO3/Sn0.2Ti0.8O2 catalyst

Different reactive behaviours of dichloromethane over anatase TiO2 supported RuO2 and V2O5

A Convenient Synthesis of Core-Shell Co3O4@ZSM-5 Catalysts for the Total Oxidation of Dichloromethane (Ch2cl2)

Catalytic Oxidation of Chlorobenzene over Ce-Mn-O<sub>x</sub>/TiO<sub>2</sub>: Performance Study of the Porous Structure

Promotional Effects of Ruthenium Oxide on Catalytic Oxidation of Dichloromethane over the Tungsten-Titanium Binary Oxides Catalyst

Low-energy production of a monolithic catalyst with MnCu-synergetic enhancement for catalytic oxidation of volatile organic compounds

High Activity of CeO2-TiO2 Composites for Deep Oxidation of 1,2-Dichloroethane

Transition Metal Doping Effect and High Catalytic Activity of CeO2–TiO2 for Chlorinated VOCs Degradation

Elimination of 1,2-Dichloroethane over (Ce,cr)(x)o-2/Moy Catalysts (M =ti, V, Nb, Mo, W and La)