Abstract:The adhesive strength and surface roughness of diamond films are the key factors to influence the cutting performance and tool life of diamond-coated tools. Compared with the sintered polycrystalline diamond, the deposited thin film diamond has the great advantage on the fabrication of cutting tools with complex geometries. Because of their low costs for fabrication equipment and high performance on high speed machining non-ferrous metals and alloys, metal-compound materials, and hard brittle non-metals, diamond-coated drills find great potentialities in the commercial application. However, the poor adhesion of the diamond film on the substrate becomes the main technical barriers for the successful development and commercialization of diamond-coated tools. In this paper, diamond thin films were deposited on WC-Co based drills by the electron aided hot filament chemical vapor deposition (EACVD). A new multiple chemical pretreatment technology including microwave oxidation, reaction in alkaline solution and cleaning by ultrasonic treatment in acid solution was developed and affects on the diamond adhesion strength, nucleation and surface morphology were investigated. At the same time, a special setup to fabricate diamond-coated drills was also developed and then the novel CV]D process based on the varied parameters controlling model was presented, therefore the uniform quality and homogenized thickness of diamond coating could be available. Composite diamond films were achieved by firstly depositing the rough polycrystalline diamond layers which had good adhesion, and then overlapping the smooth diamond layers with nanometer size grains which yielded very low roughness. From practical utilization viewpoint, the cutting performance of the diamond coated drill was studied by drilling SiC particle reinforced aluminum matrix composite. The satisfied wear resistance and decrease of torque and thrust lead to the long tool life of the diamond coated drills. This paper exhibits the meaningful work for the development of cutting tools with complex geometries and further extends application of diamond material.

Friction and wear of polycrystalline diamond in oil drilling: a review

The Wear and Friction Characters of Polycrystalline Diamond under Wetting Conditions

Effect of different base oils on the friction behaviour of polycrystalline diamond compact

Research Progress of Thermal Stability for Polycrystalline Diamond

Experimental measurement on friction performance of PDC bearings for oil drilling under different working conditions

Comparing the tribological behavior of polycrystalline diamonds against steel GCr15 and ceramic Si 3 N 4 : friction and wear

Friction and wear behaviors of polycrystalline diamond self-mated pairs in air and water lubrication conditions

Hydrophobicity and Wear Resistance of Textured Carbon Fiber/Polytetrafluoroethylene Composite Coatings

Tribological behavior of PDC-cutter including cemented carbide and polycrystalline diamond composites produced by HPHT for drilling applications

Analysis of Drilling Failure in Soft and Hard Sandwiching of Coal Seam

An advanced investigation of polycrystalline diamond compact's degradation mechanism during granite turning

Prediction of formation abrasiveness under the action of a PDC bit based on the fractal dimension of a rock surface

Friction and Wear Behavior of Polycrystalline Diamond at Temperatures Up to 700 °C

Preparation, wear resistance, and impact toughness of homoepitaxial diamond film deposited on polycrystalline diamond compact by HFCVD method

Study on Tribological Performance of Fine-Grained Diamond Films

Friction and Wear Performance of Boron Doped, Undoped Microcrystalline and Fine Grained Composite Diamond Films

Tribological Performances of Diamond Film and Graphite/diamond Composite Film

Nanomolybdenum disulfide additive improves the tribological behavior of cobalt removal polycrystalline diamond compact

Studies of Adhesion and Roughness of Diamond Coated Drills and Influence on Cutting Performance

Development of Diamond-Coated Drills for High-Speed Machining SiC Particles Reinforced Aluminum-Matrix Composite

Tribology Performance of Diamond-Like Carbon Films on Polyether-Ether-ketone Surfaces