Abstract:The sorption enhanced water gas shift (SEWGS) reaction was proposed to improve CO2 capture from blast furnace (BF) gas. The CO in the BF gas is first catalyzed to CO2 on the sorbent surface, with the formed CO2 then captured by the CaO. This process involves two reactions: the WGS reaction and the CaO carbonation reaction. The WGS reaction is a surface catalytic reaction, while the CaO carbonation is a bulk reaction. This study of the SEWGS reaction in a fluidized bed reactor showed that the sorbent type has an important effect on the SEWGS reaction, with both the CaO and MgO in the sorbent catalyzing the reaction. For calcined limestone, the WGS reaction occurs on the CaO surface with CO2 sorption in situ, but the reaction rate gradually decreases with the CaO conversion due to coverage by the CaCO3 product layer on the CaO surface. Thus, the shift reaction becomes the rate limiting step. For calcined dolomite, MgO in the sorbent does not react with CO2 and can then be used as a catalyst. The shift reaction is not a limiting step, with most of the CO2 for the CaO carbonation coming from the WGS reaction on the MgO surface. Even when the CaO surface is completely covered by the CaCO3 product, the MgO in the calcined dolomite is not completely covered by the CaCO3 product and can still catalyze the WGS reaction. An important phenomenon observed was that not only CaO but also MgO experienced the decay in the catalytic reactivity after multiple cycles. The decay of catalytic reactivity of MgO in dolomite is mainly the gradual covering of the MgO surface by CaO/CaCO3 grains, so most of the MgO grains will lose contact with the CO and the steam in the gas phase. The observation of encapsulation of MgO particles by CaO or CaCO3 is also important for understanding the stabilization of synthetic calcium based sorbent with support addition.

Investigating the behavior of six limestones in presence of steam in dual interconnected fluidized beds, under operating conditions relevant for sorption-enhanced gasification

Evolution of Limestone Particle Size Distribution in an Air-Jet Attrition Apparatus

CO2 Capture from Flue Gases Using Three Ca-Based Sorbents in a Fluidized Bed Reactor

Experiment And Modeling Of Co(2) Capture From Flue Gases In A Fluidized Bed With Limestone And Dolomite Sorbents

Experiment and Modeling of Co2 Capture from Flue Gases at High Temperature in A Fluidized Bed Reactor with Ca-Based Sorbents

Morphological Changes of Limestone Sorbent Particles during Carbonation/Calcination Looping Cycles in a Thermogravimetric Analyzer (TGA) and Reactivation with Steam

Experimental Research on CaO Carbonation/Calcination Cycles in Fluidized Bed

Experiments on H2S sorption by limestone in a fluidized bed gasifier

Comparative investigation on CO2 uptake performance of limestone-derived sorbents with different supports synthesized by impregnated layer solution combustion method

High-Temperature Attrition of Nano CaO-Based CO2-Reactive Adsorbents in the Calcium Looping Process

In-situ XRD Studies of dolomite based CO2 sorbents

Post combustion CO2 capture with calcium and lithium hydroxide

Process Analysis of CO2 Capture from Flue Gas Using Carbonation/calcination Cycles

Degradation Study of a Novel Polymorphic Sorbent under Realistic Post-Combustion Conditions

Experimental Study on Calcination and Fragmentation Characteristics of Limestone in Fluidized Bed

Effect of sorbent type on the sorption enhanced water gas shift process in a fluidized bed reactor

Attrition and morphological analysis of CaCO 3 corresponding to oxy-fuel circulating fluidized bed conditions

Effect of characteristic of sorbents on their sulfur capture capability at a fluidized bed condition

Limestone Attrition and Product Layer Development During Fluidized Bed Sulfation

Sorbent performance under FBC conditions-a thermochemical analysis

Experimental study of steam reactivation of calcium-based sorbent for dry FGD process