Abstract:This study investigated the physical and chemical characteristics of a Korean limestone used in a large-scale CFB boiler under simultaneous calcination and sulfation conditions in a laboratory-scale fluidized bed reactor. The conversion rate and maximum conversion degree of sulfation under simultaneous conditions were found to be lower than those under subsequent calcination and sulfation conditions. The development of the product layer during sulfation impedes the calcination reaction and results in a lower pore growth rate, which leads to a reduction in the available reaction surface area for the sulfation reaction. The simultaneous pore growth of calcination and product layer development of sulfation eventually lead to a lower rate and reduction in the maximum conversion degrees of both calcination and sulfation. Under simultaneous conditions, the elutriation rate is found to be higher than that under subsequent conditions; this is attributed to the inhibited calcination and sulfation under simultaneous conditions. To investigate the development of the product layer, the microstructure of limestone particles was studied via a scanning electron microscope coupled with an energy-dispersive X-ray analyzer. This paper reports the characteristics of the product layer development during the different sulfation reaction regimes that were found to be significant for understanding the characteristics of both the conversion degree and elutriation rate. The findings of this work can provide an insight into the physical and chemical behaviors of limestone under simultaneous conditions in a fluidized bed reactor to better comprehend the mechanism of desulfurization in CFB boilers.

Evolution of Limestone Particle Size Distribution in an Air-Jet Attrition Apparatus

Attrition characteristics and mechanisms for limestone particles in an air-jet apparatus

Limestone Particle Attrition in High-Velocity Air Jets

Limestone Attrition and Product Layer Development During Fluidized Bed Sulfation

Attrition Performance and Morphology of Limestone under Different Conditions in Fluidized Bed

Attrition of limestone during fluidized bed calcination and sulfation

Attrition and morphological analysis of CaCO 3 corresponding to oxy-fuel circulating fluidized bed conditions

An Experimental Study on the Primary Fragmentation and Attrition of Limestones in a Fluidized Bed

Experimental Study on Calcination and Fragmentation Characteristics of Limestone in Fluidized Bed

Measurement and Numerical Simulation of Ultrafine Particle Size Distribution in the Early Stage of High-Sodium Lignite Combustion

High-Temperature Attrition of Nano CaO-Based CO2-Reactive Adsorbents in the Calcium Looping Process

Attrition of CaO-based adsorbent in a laboratory-scale fluidized system

Investigating the behavior of six limestones in presence of steam in dual interconnected fluidized beds, under operating conditions relevant for sorption-enhanced gasification

Sorbent Performance under FBC Conditions -- A Thermochemical Analysis

Morphological Changes of Limestone Sorbent Particles during Carbonation/Calcination Looping Cycles in a Thermogravimetric Analyzer (TGA) and Reactivation with Steam

Effects Of The Limestone Particle Size On The Sulfation Reactivity At Low So2 Concentrations Using A Lc-Tga

Attrition and Product Layer Development of Limestone During Simultaneous Calcination and Sulfation in a Fluidized Bed Reactor

Insights into the Desulfurization Mechanism of Low-Grade Limestone As Absorbent Induced by Particle Size

Sorbent performance under FBC conditions-a thermochemical analysis

Attrition Behavior of Fine Particles in a Fluidized Bed with Bimodal Particles: Influence of Particle Density and Size Ratio

Characterization of the sulfation reactivity of limestones with different particle size in a large-capacity TGA