Investigation of highly efficient adsorbent based on Ni-MOF-74 in the separation of CO2 from natural gas

Shujun Chen,Xuejian Li,Jun Duan,Yue Fu,Zeyuan Wang,Min Zhu,Na Li

DOI: https://doi.org/10.1016/j.cej.2021.129653

IF: 15.1

2021-09-01

Chemical Engineering Journal

Abstract:Ni-MOF-74 is used in the separation of CO2 from natural gas. However, its low selectivity coefficient for CO2 limits its application. To address this limitation, –CH3, –NH2, -F, and -O-Li groups were introduced to modify Ni-MOF-74. First, the adsorption of pure CO2 on metal–organic frameworks (MOFs) was simulated using the grand canonical Monte Carlo (GCMC) method. The CO2 adsorption capacities of adsorbents modified with -F and -O-Li were respectively 36.5% and 26.95% higher than that of unmodified Ni-MOF-74. The adsorption of a CH4/CO2 mixture on the MOFs was also studied. Ni-MOF-74 modified with -O-Li, denoted as Li-O-Ni-MOF-74, had the highest selectivity coefficient among the modified adsorbents. This was explained based on the analysis of the isosteric heat of adsorption and the electrostatic potential distribution gradient. The specific surface area and pore volume of Li-O-Ni-MOF-74 were respectively 162.03% and 86.42% higher than those of Ni-MOF-74, according to microstructure analysis. This also proved that the modified adsorbent has a higher adsorption capacity. Penetration experiments involving a CO2/CH4 mixture at different flow rates were carried out by an adsorption experiment device. The penetration time and separation factor of Li-O-Ni-MOF-74 were higher than those of Ni-MOF-74. Therefore, an efficient adsorbent based on Ni-MOF-74 for the separation of CO2 from natural gas was identified through GCMC simulation and experimental analysis. This study will help improve the efficiency of natural gas deacidification.

engineering, chemical, environmental

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: to improve the selective adsorption capacity of Ni - MOF - 74 for CO2, so as to separate CO2 from natural gas more efficiently. Specifically:

1. **Background problems**:
- Decarbonization (removal of CO2) of natural gas is a crucial step in the natural gas development process, which affects the quality of natural gas and the service life of equipment.
- Although Ni - MOF - 74 shows good performance in CO2 adsorption, its selectivity coefficient is low, which limits its practical application.

2. **Research objectives**:
- Modify Ni - MOF - 74 by introducing different functional groups (such as –CH3, –NH2, -F, and -O - Li) to improve its selectivity and adsorption capacity for CO2.
- Explore the performance of the modified MOFs in the separation of CO2/CH4 mixed gases, and analyze the influence of their microstructures and charge distributions on the adsorption performance.

3. **Specific problems**:
- How can the CO2 adsorption selectivity of Ni - MOF - 74 be improved through modification?
- How does the adsorption performance of the modified MOFs change under different conditions?
- What is the influence of the microstructure and charge distribution of the modified material on its adsorption performance?

Through these studies, the paper aims to find an efficient adsorbent that can significantly improve the efficiency of separating CO2 from natural gas, thereby providing a new solution for natural gas purification.