Grand canonical Monte Carlo simulation of the adsorption and separation of carbon dioxide and methane using functionalized Mg-MOF-74

Guanhua Zhang,Youshan Liang,Guomin Cui,Binlin Dou,Wei Lu,Qiguo Yang,Xiaoyu Yan
DOI: https://doi.org/10.1016/j.egyr.2023.01.121
IF: 5.2
2023-02-09
Energy Reports
Abstract:Grand canonical Monte Carlo (GCMC) simulations were used to analyse the effect of -O-Li, -NH 2 , -SH, -F, -COOH, and -NO 2 functional groups on the adsorption and separation of pure CO 2 and a mixture of CO 2 and CH 4 . The metal–organic framework (MOF) skeleton was structurally optimized using the Forcite and Dmol 3 modules. First, the GCMC method was employed to simulate the adsorption of pure CO 2 by functionalized Mg-MOF-74 at 298 K and 10–3000 kPa. The results illustrated that -O-Li, -NH 2 , and -SH groups increased the CO 2 adsorption below 101 kPa and followed the order Li-O-Mg-MOF-74 > NH 2 -Mg-MOF-74 > SH-Mg-MOF-74. When the pressure was >101 kPa, the adsorption capacity of Mg-MOF-74 was higher than that of functionalized Mg-MOF-74. Then, the adsorption capacity and selectivity of functionalized Mg-MOF-74 in the CO 2 /CH 4 mixture were investigated at 298 K and 10–3000 kPa. The results showed that the introduction of -O-Li, -NH 2 , and -SH groups increased the CO 2 selectivity of Mg-MOF-74 within the range of 10–1440 kPa and followed the order Li-O-Mg-MOF-74 > NH 2 -Mg-MOF-74 > SH-Mg-MOF-74.
energy & fuels
What problem does this paper attempt to address?