Abstract:During the past few decades, several studies have been conducted to characterize the performance of in-service, girder-type bridge superstructures under operating conditions. Few of these efforts have focused on evaluating the actual response of the bridge systems — especially beyond the elastic limit of their behavior — and correlating the impact of damage to the overall system behavior. In practice, most of the in-service bridge superstructures behave elastically under the routine daily traffic. However, existing damage and deteriorating conditions would significantly influence different aspects of the structural performance, including reserve capacity, resilience and remaining service-life. The main purpose of this study is to evaluate the response of composite steel girder bridges under the effect of subsurface delamination in the reinforced concrete deck. Commercial finite element computer software, ANSYS, was implemented to perform a nonlinear analysis on a representative single-span, simply-supported bridge superstructure. The system failure characteristics were captured in the numerical models by incorporating different sources of material non-linearities, including cracking/crushing in the concrete and plasticity in steel components. Upon validation, non-linear behavior of the system, with both intact and degraded configurations, was used to evaluate the impact of integrated damage mechanism on the overall system performance. Reserve capacity of this bridge superstructure was also determined with respect to the nominal element-level design capacity. As vision to the future path, this framework can be implemented to evaluate the performance of other in-service bridges degraded under the effect of different damage scenarios, thus providing a mechanism to determine a measure of capacity, resilience and remaining service-life.

Time-dependant effects on curved precast segmentally constructed balanced cantilever bridges

Time-dependent behavior of PC box girder bridges considering non-uniform shrinkage and creep

Simulating analysis of cantilever casting of prestressed concrete bridge

Spatial behavior and strengthening analysis of fabricated PC hollow slab beam bridge with hinge joints

Analysis of Ultimate Loading Capacity of the Prestressed Concrete Curved Bridge

Simulation of cantilever-casting construction of prestressed concrete cable-stayed bridge

Reinforcement Analysis of an Old Multi-Beam Box Girder Based on a New Embedded Steel Plate (ESP) Strengthening Method

Coupled Effect of Loading and Environment of Concrete Bridge in Service Life

Influence of effect of creeping of the long span prestressed concrete cable-stayed bridge on internal forces in structural health monitoring

Time-dependent creep and shrinkage analysis of curved steel–concrete composite box beams

Long-Term Deflection of Prestressed Concrete Bridge Considering Nonuniform Shrinkage and Crack Propagation by Equivalent Load Approach

Evaluating the Effect of the Compressive Strength Development Factor on Concrete Creep Deformation in Bridge Construction

Experimental Study on Stability of Long-Span PC Cable-Stayed Bridge during the Construction Periods

Effect of Deck Deterioration on Overall System Behavior, Resilience and Remaining Life of Composite Steel Girder Bridges

Failure Patterns and Ultimate Load-Carrying Capacity Evolution of a Prestressed Concrete Cable-Stayed Bridge: Case Study

Nonlinear Analysis of External Post-Tensioning anchorage of Concrete Segment

Time-Dependent Flexural Deformations in Composite Prestressed Concrete and Steel Bridge Beams. II: Comparison of Predictions

Analysis Method for the Prestressed Concrete Bridges Based on Time-Dependent Theory

Three-dimensional finite element analyses for cyclic responses of precast segmental bridge piers accounting for bond-slip degradation

Effects of thermal cycles and time-dependent behavior of the deck on steel network arch bridges

Profile Control of Large-Span Tapered Girder Bridges with Corrugated Steel Webs During Cantilever Construction Progress