Design and Non-Linearity Optimization of a Vertical Brushless Electric Power Steering Angle Sensor

Jie Chen,Yanling Guo
DOI: https://doi.org/10.3390/s24082469
IF: 3.9
2024-04-13
Sensors
Abstract:This paper presents the design and the non-linearity optimization of a new vertical non-contact angle sensor based on the electromagnetic induction principle. The proposed sensor consists of a stator part (with one solenoidal excitation coil and three sinusoidal receiver coils) and a rotor part (with six rectangular metal sheets). The receiver coil was designed based on the differential principle, which eliminates the effect of the excitation coil on the induced voltage of the receiver coil, and essentially decouples the excitation field from the eddy current field. Moreover, the induced voltages in the three receiver coils are three-phase sinusoidal signals with a phase difference of 10°, which are linearized by CLARK transformation. To minimize the sensor non-linearity, the Plackett–Burman technique was used, which identified the stator radius and the rotor blade thickness as the key factors affecting the sensor linearity. Then, the particle swarm algorithm with decreasing inertia weights was utilized to optimize the sensor linearity. A sensor prototype was made and tested in the laboratory, where the experimental results showed that the sensor non-linearity was only 0.648% and 0.645% in the clockwise and counterclockwise directions, respectively. Notably, the non-linearity of the sensor was less than −0.696% at different speeds.
engineering, electrical & electronic,chemistry, analytical,instruments & instrumentation
What problem does this paper attempt to address?
The problem that this paper attempts to solve is to design and optimize the nonlinearity problem of a new type of vertical non - contact inductive angle sensor. Specifically, the research aims to reduce the nonlinear error of the sensor through structural parameter optimization, thereby improving its measurement accuracy and reliability. The following are the specific problems mentioned in the paper: 1. **Defects of existing electromagnetic inductive angle sensors**: - The planar structure results in a relatively large sensor size. - The crosstalk between the two rotors affects the nonlinearity of the sensor. 2. **The influence of nonlinearity on sensor performance**: - Nonlinearity is one of the important parameters for measuring sensor performance. Unreasonable structural parameters will lead to distortion of the induced sine waveform, which in turn causes a relatively large nonlinear error. 3. **Selection of optimization methods**: - The paper uses the Plackett - Burman technique to screen out the key factors affecting the linearity of the sensor (such as stator radius and rotor blade thickness). - Further use the Particle Swarm Optimization (PSO) algorithm to optimize these key factors in order to minimize the nonlinear error of the sensor. 4. **Experimental verification**: - A sensor prototype was fabricated and tested in the laboratory. The results show that the nonlinear errors of the sensor in the clockwise and counterclockwise directions are 0.648% and 0.645% respectively, and the nonlinear error is less than - 0.696% at different speeds. ### Summary The main objective of the paper is to reduce the nonlinear error of a new type of vertical non - contact inductive angle sensor through design and optimization, thereby improving the measurement accuracy and reliability of the sensor. To this end, the author uses the Plackett - Burman technique and the Particle Swarm Optimization algorithm to optimize the structural parameters and verifies the optimization effect through experiments.