Abstract:The current research of real-time observation for vehicle roll steer angle and compliance steer angle(both of them comprehensively referred as the additional steer angle in this paper) mainly employs the linear vehicle dynamic model, in which only the lateral acceleration of vehicle body is considered. The observation accuracy resorting to this method cannot meet the requirements of vehicle real-time stability control, especially under extreme driving conditions. The paper explores the solution resorting to experimental method. Firstly, a multi-body dynamic model of a passenger car is built based on the ADAMS/Car software, whose dynamic accuracy is verified by the same vehicle’s roadway test data of steady static circular test. Based on this simulation platform, several influencing factors of additional steer angle under different driving conditions are quantitatively analyzed. Then ɛ-SVR algorithm is employed to build the additional steer angle prediction model, whose input vectors mainly include the sensor information of standard electronic stability control system(ESC). The method of typical slalom tests and FMVSS 126 tests are adopted to make simulation, train model and test model’s generalization performance. The test result shows that the influence of lateral acceleration on additional steer angle is maximal (the magnitude up to 1°), followed by the longitudinal acceleration-deceleration and the road wave amplitude (the magnitude up to 0.3°). Moreover, both the prediction accuracy and the calculation real-time of the model can meet the control requirements of ESC. This research expands the accurate observation methods of the additional steer angle under extreme driving conditions.

Design and Algorithm Research of Angle Sensor for Vehicle Steering Wheel

Research Development of Steering Wheel Angle Sensor

Angle Sensor Module for Vehicle Steering Device Based on Multi-Track Impulse Ring

Study on Differential Assist Steering System with Double In-Wheel Motors with Intelligent Controller

A model predictive control approach for angle tracking of steer‐by‐wire system with nonlinear transmission ratio

Nonlinear Steering Wheel Angle Control Using Self-Aligning Torque with Torque and Angle Sensors for Electrical Power Steering of Lateral Control System in Autonomous Vehicles

Research advances in vehicle lateral motion monitoring and control

Design and Non-Linearity Optimization of a Vertical Brushless Electric Power Steering Angle Sensor

Research on Design of Variable Gear Ratio of Steer-by-Wire System and Comprehensive Feedback Control of Front Wheel Angle

Design of Non-Contact Torque Sensor for Electric Power Steering System

Development and Prospect of Automobile Four-Wheel Steering System

Research on Highly Precise Angle-differentiated Measuring and Auto-controlling System

Triboelectric nanogenerator sensors for intelligent steering wheel aiming at automated driving

Fault Diagnosis and Fault-Tolerant Compensation Strategy for Wheel Angle Sensor of Steer-by-Wire Vehicle via Extended Kalman Filter

Control Analysis of Vehicle Steering System based on Closed-Loop Control Algorithm

Robust Steering Angle Tracking Control for Steer-by-wire System

Research on control strategy and bench test of automobile Steer-by-Wire system

A Model-Tuned Predictive Backstepping Control Approach for Angle Following of Steer-by-Wire

Experimental Model and Analytic Solution for Real-Time Observation of Vehicle’s Additional Steer Angle

Research on Vehicle Active Steering Control Based on Linear Matrix Inequality and Hardware in the Loop Test Scheme Design and Implement for Active Steering

Application Research of Parameter Uncertainty Optimization Method in Steering Detection and Correction System