Abstract:Conventional vehicle electronic stability control requires one steering-wheel angle sensor, one lateral acceleration sensor and one yaw rate sensor to obtain a good control performance. The control system stops working when a sensor fault is detected, which means that the vehicle runs in an unprotected state. Thus, various sensor fault diagnosis algorithms have been designed to detect and isolate the faulty sensor, but these algorithms also can be used for fault-tolerant control to preserve the safety of the vehicle. However, determining which of the different sensors is faulty is very difficult as the conventional residual comparison algorithm can only find the existence of a sensor fault but cannot locate the faulty sensor, and very few research studies have focused on this problem. In this paper, an ingenious sensor fault diagnosis algorithm is proposed. The sensor fault is detected, located and isolated by cross-checking with three different yaw rate estimates. The steering-wheel angle observer and the lateral acceleration observer are designed to provide corresponding estimated sensor signals which are employed to estimate the different yaw rates by using an extended Kalman filter. A novel decision-making process is carefully designed to locate the faulty sensor based on the different yaw rate residuals. Electronic stability control is not interrupted as the faulty sensor signal is reconfigured by the estimated signal. Experimental tests on a real car show that the proposed algorithm is efficient for detecting the sensor fault and identifying which sensor is faulty. Simulations show that the vehicle stability control strategy based on the proposed sensor fault-tolerant control algorithm has a better performance than the traditional control strategy does.

Research Development of Steering Wheel Angle Sensor

Design and Algorithm Research of Angle Sensor for Vehicle Steering Wheel

Study on Differential Assist Steering System with Double In-Wheel Motors with Intelligent Controller

The Research on Sensor Optimal Layout on Detection Device for Automobile Seat Horizontal Drive Mechanism

Research on Force Characteristics of Steering-wheel System in Tracked Vehicle Simulator

Angle Sensor Module for Vehicle Steering Device Based on Multi-Track Impulse Ring

A model predictive control approach for angle tracking of steer‐by‐wire system with nonlinear transmission ratio

Study on an inductive steering speed sensor

Design of Non-Contact Torque Sensor for Electric Power Steering System

Fault Diagnosis and Fault Tolerance Degradation Control Based on Fuzzy Decision for RSAS of Redundant Braking System

Triboelectric nanogenerator sensors for intelligent steering wheel aiming at automated driving

Research on Design of Variable Gear Ratio of Steer-by-Wire System and Comprehensive Feedback Control of Front Wheel Angle

Nonlinear Steering Wheel Angle Control Using Self-Aligning Torque with Torque and Angle Sensors for Electrical Power Steering of Lateral Control System in Autonomous Vehicles

Fault Diagnosis and Fault-Tolerant Compensation Strategy for Wheel Angle Sensor of Steer-by-Wire Vehicle via Extended Kalman Filter

Design and Non-Linearity Optimization of a Vertical Brushless Electric Power Steering Angle Sensor

Research on control strategy and bench test of automobile Steer-by-Wire system

Experimental Model and Analytic Solution for Real-Time Observation of Vehicle’s Additional Steer Angle

Research on Steering Detection and Correction Method Based on Integrated GNSS/INS/Magnetometer

Model-based Sensor Fault Detection and Isolation Method for a Vehicle Dynamics Control System

Research on steering detection and correction method based on integrated GNSS/INS/Magnetometer.

Optimization of Rotor Angle Signal for Permanent Magnet Synchronous Motor