Abstract:We present a method for fabricating general models with multi-directional 3-D printing systems by printing different model regions along with different directions. The core of our method is a support-effective volume decomposition algorithm that minimizes the area of the regions with large overhangs. A beam-guided searching algorithm with manufacturing constraints determines the optimal volume decomposition, which is represented by a sequence of clipping planes. While current approaches require manually assembling separate components into a final model, our algorithm allows for directly printing the final model in a single pass. It can also be applied to models with loops and handles. A supplementary algorithm generates special supporting structures for models where supporting structures for large overhangs cannot be eliminated. We verify the effectiveness of our method using two hardware systems: a Cartesian-motion-based system and an angular-motion-based system. A variety of 3-D models have been successfully fabricated on these systems. Note to Practitioners-In conventional planar-layer-based 3-D printing systems, supporting structures need to be added at the bottom of large overhanging regions to prevent material collapse. Supporting structures used in single-material 3-D printing technologies have three major problems: being difficult to remove, introducing surface damage, and wasting material. This article introduces a method to improve 3-D printing by adding rotation during the manufacturing process. To keep the hardware system relatively inexpensive, the hardware, called a multi-directional 3-D printing system, only needs to provide unsynchronized rotations. In this system, models are subdivided into different regions, and then, the regions are printed in different directions. We develop a general volume decomposition algorithm for effectively reducing the area that needs supporting structures. When supporting structures cannot be eliminated, we provide a supplementary algorithm for generating supports compatible with multi-directional 3-D printing. Our method can speed up the process of 3-D printing by saving time in producing and removing supports.

Implementation of a robotic framework for multi-axis supportless fused filament fabrication via volume decomposition: a practical approach

Design and Validation of 3D Self-Supporting Structures and Printing Paths for Multi-Axis Additive Manufacturing

RoboFDM: A Robotic System for Support-Free Fabrication Using FDM.

Layout and Geometry Optimization Design for 3D Printing of Self-Supporting Structures

Robotic additive manufacturing system for dynamic build orientations

Design and Build of a Tele-Operated and Robot-Assisted Multi-Material 3D Printer System

Research on Large-Scale Additive Manufacturing Based on Multi-Robot Collaboration Technology

A hybrid additive manufacturing platform based on fused filament fabrication and direct ink writing techniques for multi-material 3D printing

Support-free volume printing by multi-axis motion.

Multi-Axis 3D Printer Design Challenges for In-Situ Additive Manufacturing

A Trivariate T-spline Based Direct-Slicing Framework for Support-Free Additive Manufacturing

General Support-Effective Decomposition for Multi-Directional 3-D Printing

Design and Optimization of a Control Framework for Robot Assisted Additive Manufacturing Based on the Stewart Platform

Robotic 3D Printing of Continuous Fiber Reinforced Thermoset Composites

Research on a Support-Free Five-Degree-of-Freedom Additive Manufacturing Method

Research on the flexible support platform for fused deposition modeling

Fused deposition modeling-based additive manufacturing (3D printing): techniques for polymer material systems

Fused Filament Fabrication Process: A Review of Numerical Simulation Techniques

Towards Intelligent Cooperative Robotics in Additive Manufacturing: Past, Present and Future

An overview of fused deposition modelling (FDM): research, development and process optimisation

Roadmap: Numerical-Experimental Investigation and Optimization of 3D-Printed Parts Using Response Surface Methodology