Research on the flexible support platform for fused deposition modeling

Shen Hongyao,Ye Xiaoxiang,Fu Jianzhong

DOI: https://doi.org/10.1007/s00170-018-2046-2

IF: 3.563

2018-05-23

The International Journal of Advanced Manufacturing Technology

Abstract:Traditional fused deposition modeling (FDM) additive manufacturing technologies usually fabricate a 3D physical model layer by layer. However, support structure under cantilever geometry and model unloading are two major drawbacks of the FDM technology that waste material and hamper the automation of FDM. This paper designs a kind of flexible support platform for assisting FDM to avoid waste and promote automation of FDM, which consists of basic units controlled to rise and fall by the computer. During the printing process, the platform can form different support structures using basic units for different models. When the printing process is finished, basic units rise to unload the model from the platform. Typical models were printed to verify efficiency of support structure reduction, and effects of the model’s position on reduction were studied. The automatic unloading of the flexible platform was simulated to study the stress state and then the mechanical test was put into effect to measure the actual value of pressure. In the last part, parameters of unloading successfully are given to guide the unloading process.

What problem does this paper attempt to address?

The problems that this paper attempts to solve are the two major drawbacks in traditional Fused Deposition Modeling (FDM) technology: support structures and model unloading. Specifically:

1. **Support structure problems**:
- During the FDM 3D printing process, cantilever geometries require additional support structures to prevent the model from collapsing.
- These support structures not only waste materials, increase printing time, but also increase the surface roughness of the surfaces in contact with the support structures.

2. **Model unloading problems**:
- When the model is printed, the traditional unloading process relies on manual operations, which is inefficient and easily damages the fragile structures of the model.
- Manual unloading requires the operator to find the starting point of the model and use tools to pry it off the platform. This method lacks theoretical guidance and is difficult to achieve automated separation.

To solve these problems, the paper designs a flexible support platform, aiming to reduce the need for support structures and achieve automatic unloading. The platform consists of computer - controlled basic units, which can rise or fall as needed during the printing process to form different support structures, and unload the model from the platform by raising the basic units after printing is completed. In this way, material waste can be significantly reduced and the degree of automation of FDM technology can be improved.

### Key formulas

- The calculation formula for the height offset value (offset value) of the support structure:
\[
h_{\text{offset}} = z_{\text{model}} - z_{\text{platform}}
\]
where \( z_{\text{model}} \) is the Z - coordinate value at the bottom of the model, and \( z_{\text{platform}} \) is the height of the platform.

- The distribution function of the maximum pressure \( \sigma_p \) during automatic unloading:
\[
\sigma_p(x) = \sigma_0 e^{-kx}
\]
where \( \sigma_0 \) is the maximum pressure value, \( k \) is the attenuation coefficient, and \( x \) is the position from the boundary.

Through these improvements, the paper demonstrates the effectiveness and feasibility of the flexible support platform in reducing support structures and achieving automatic unloading.