Abstract:In this study, a novel sol-gel method is used to synthesize amorphous silica-alumina materials with a narrow mesoporous distribution and various Si/Al molar ratios without using any templates and pore-regulating agents. During the preparation procedure, only inexpensive inorganic salts were used as raw materials, instead of expensive and harmful alkoxides. The precursor sol was dried at room temperature in a vacuum box kept at 60 mmHg until it began to form the gel. The results of a nitrogen sorption experiment indicate that the synthesized materials with different Si/Al molar ratios have similar mesoporous distributions (within 2-12 nm). Moreover, it was found that the material's pore size distribution remains at a similar value during the heat treatment from room temperature to 550 degreesC. On the basis of the nitrogen sorption, TEM, and AFM characterization results, a formation mechanism of mesopores which accounts for the experimental data is also suggested. This suggested mechanism involves rearrangement of the primary particles during the drying process to form the precursors of the similarly sized mesopores. The synthesized materials were characterized by XRD, thermal analysis (TG/DTA), Al-27 and Si-29 MAS NMR spectroscopy, SEM, TEM, and AFM. The results of Al-27 and 29Si MAS NMR indicate that the distribution of silicon and aluminum in the synthesized materials is more uniform and homogeneous than that in the mixed oxides prepared via the traditional sol-gel method even at high alumina contents. The type and density of the acid sites were studied using pyridine adsorption-desorption FTIR spectroscopy. It was shown that the acidity of the synthesized materials is higher than that of the silica-alumina materials prepared by conventional methods.

Microwave-assisted solvothermal synthesis of hollow mesoporous SiOC ceramics in NaOH solution

Effect of HF and NaOH Etching on Chemical and Structure Stability of Hollow SiOC Ceramics

Influence of CaO content by mass in sintering aid and sintering temperature on the properties of Al2O3-based microwave ceramic materials

Mechanochemical Nonhydrolytic Sol–Gel-Strategy for the Production of Mesoporous Multimetallic Oxides

High Temperature Structure Evolution of Macroporous SiOC Ceramics Prepared by a Sol–gel Method

Preparation of Porous Si2N2O/SiC Ceramics by Microwave Sintering

Synthesis and microwave dielectric properties of (Ca0.7Mg0.3)SiO3 nanopowder prepared at low temperature

One-pot Template-Free Synthesis of Mesoporous Boehmite Core–shell and Hollow Spheres by a Simple Solvothermal Route

In-situ reaction strategy toward Sc 2 O 3 reinforced SiOC ceramics for enhanced microwave absorption performance

Synthesis of mesoporous silica hollow spheres in supercritical CO2/water systems

Synthesis and Microwave Dielectric Properties of CaSiO3 Nanopowder by the Sol–gel Process

Preparation of Amorphous SiOC Ceramic Powders through Precursor Polymer Pyrolysis

Temperature field regulation and growth mechanism of SiC fiber during microwave synthesis with catalyst assistance

Effect of sol-gel and solid-state synthesis techniques on structural, morphological, dielectric properties and sintering mechanism of Li2ZnTi3O8 microwave ceramics

Preparation of Low Temperature Cofired CaO-MgO-SiO2 Microwave Ceramics Doped with Additives by Sol-Gel Method

Multiscale design and digital light processing preparation of high-strength SiOC ceramic metastructures for tuning microwave absorption properties

A Simple and Efficient Way to Prepare Porous Mullite Matrix Ceramics Via Directly Sintering SiO2-Al2O3 Microspheres

Synthesis and crystal morphology control of AlPO4-5 molecular sieves by microwave irradiation

Ordered Mesoporous SiOC and SiCN Ceramics from Atmosphere-Assisted in Situ Transformation

Fabrication and properties of Si2N2O ceramics for microwave sintering furnace

A Novel Method To Synthesize Amorphous Silica−Alumina Materials with Mesoporous Distribution without Using Templates and Pore-Regulating Agents