Abstract:Abstract The thermal gravimetric analysis (TG) is a common method for the examination of the carbonation progress of cement-based materials. Unfortunately, the thermal properties of some components complicate the evaluation of TG results. Various hydrate phases, such as ettringite (AFt), C–S–H and AFm, decompose almost simultaneously in the temperature range up to 200 °C. Additionally, physically bound water is released in the same temperature range. In the temperature range between 450 °C and 600 °C, the decomposition of calcium hydroxide and amorphous or weakly bound carbonates takes place simultaneously. Carbonates, like calcite, from limestone powder or other additives may be already contained in the noncarbonated sample material. For this research, an attempt was made to minimise the influence of these effects. Therefore, differential curves from DTG results of noncarbonated areas and areas with various states of carbonation of the same sample material were calculated and evaluated. Concretes based on three different types of cement were produced and stored under accelerated carbonation conditions (1% CO 2 in air). The required sample material was obtained by cutting slices from various depths of previously CO 2 -treated specimen and subsequent grinding. During the sample preparation, a special attention was paid that no additional carbonation processes took place. As reference method for the determination of the carbonation depth, the sprayed application of phenolphthalein solution was carried out. Microscopic analysis was examined to confirm the assumptions made previously. Furthermore, the observed effect of encapsulation of calcium hydroxide by carbonates caused by the accelerated carbonation conditions was examined more closely.

CARBONATION DEGREE IN CEMENTITIOUS MATERIALS BASED ON NONDESTRUCTIVE TESTING

Mechanism Analysis on Carbonation of Hardened Cement Paste with XCT

Enhanced Carbonation Curing of Cement Pastes with Dolomite Additive

Microstructure Refinement of Calcium-Sulfate-aluminate and Portland Cement (CSA-PC) Hybrids with Accelerated CO2 Curing (ACC)

Multi technique characterization of the carbonation affected zone including non-destructive single sided 1 H NMR

Carbonation Process Simulation for Cement-Based Materials Based on Microstructure by a Cement Hydration Model

Development of more accurate methods for determining carbonation depth in cement-based materials

Quantitative Analysis of Carbonation Degree of Mortar Based on Multiple Interactive Influences

Evaluation on effect of carbonation on chloride binding capacity and stability of cement hydration products with multiple testing methods

Application of Infrared Spectroscopy in the Measurement of Carbonation Depth of Concrete

XRD and 29Si MAS NMR study on carbonated cement paste under accelerated carbonation using different concentration of CO2

Quantitative evaluation of cement paste carbonation using Raman spectroscopy

Quantification of carbonated Mg-based cement pastes by Raman spectroscopy

Description of the concrete carbonation process with adjusted depth-resolved thermogravimetric analysis

Mechanical Properties and Carbonation Durability of Engineered Cementitious Composites Reinforced by Polypropylene and Hydrophilic Polyvinyl Alcohol Fibers

Microstructure Modification of Carbonated Cement Paste with Six Kinds of Modern Microscopic Instruments

Effects of Crack and Itz and Aggregate on Carbonation Penetration Based on 3d Micro X-Ray Ct Microstructure Evolution

Carbonation of Pure Minerals in Portland Cement: Evolution in Products as a Function of Water-to-solid Ratio

Comparison of detection methods for carbonation depth of concrete

Application of X-Ray Micro-CT for Quantifying Degree of Hydration of Slag-Blended Cement Paste

Carbonation-hardening properties and ITZ microstructure of low-calcium CO2 sequestration binder mortar