Abstract:Face-centered cubic (fcc) high and medium entropy alloys (H/MEAs) have been shown to display superior mechanical properties at low temperatures, but significant improvement of their strength at high temperatures is required for industrial applications at extreme conditions. Recently, it has been shown that the breakthrough of the MEAs from equiatomic/near-equiatomic to non-equiatomic ratios leads to strong MEAs with good ductility. To design new H/MEAs, we consider two important factors that may influence strength: the chemical composition and chemical short range order (CSRO). In this study, we investigate the depinning stress ( σ c ) as a criterion of strength of several compositions of VCoNi concentrated solid solution alloys (CSSAs) including V 0.33 Co 0.33 Ni 0.33 , V 0.35 Co 0.2 Ni 0.45 , V 0.33 Co 0.17 Ni 0.5 , and V 0.17 Co 0.33 Ni 0.5 at 5 K and 300 K, using atomistic simulations. The chosen interatomic potential is shown to be reliable by comparing experimental/ ab initio values and calculated parameters such as lattice constant, shear modulus, depinning stress, and temperature variation of stacking fault width for equimolar VCoNi. We find a good agreement between experimental friction stress and the depinning stress extracted from our results for equimolar VCoNi. Also, we find that Vclusters are the main pinning points of dislocations, and With a random distribution of atoms, we find that the alloy composition V 0.33 Co 0.17 Ni 0.5 displays the largest depinning stress at both 5 and 300 K. Furthermore, to investigate how CSRO affects the strength of these alloys, we design CSRO into the microstructure using two different methods: In the first method, hybrid Molecular-dynamics/Monte-Carlo simulations were employed to simulate annealing at various temperatures. We observe that such simulations create CSRO so that it increases with decreasing annealing temperature. Recently, the CSRO motif and its concentration in an equimolar VCoNi have been determined by experiment. By modeling this experiment, we also implemented the CSRO into microstructure as the second method. By using both methods, the effect of CSRO on the magnitude of the depinning stress is discussed. It was shown that in both methods, CSRO significantly influences the strength of non-equimolar VCoNi alloys.

Dynamic precipitation-induced the negative strain rates sensitivity in VCoNi medium-entropy alloy

A Molecular Dynamics Study on Mechanical Performance and Deformation Mechanisms in Nanotwinned NiCo-based Alloys with Nano-Precipitates under High Temperatures

Analysis of deformation behavior of VCoNi medium-entropy alloy at temperatures ranging from 77 K to 573 K

Ultrahigh grain boundary strengthening ability of VCoNi medium entropy alloy

Effects of V Addition on the Deformation Mechanism and Mechanical Properties of Non-Equiatomic CoCrNi Medium-Entropy Alloys

Real-time Atomic Deformation Behavior of Nano CoCrCuFeNi High-Entropy Alloy

Abnormal strain-hardening in Co-rich CoNiV medium-entropy alloys

Dynamic tensile deformation and microstructural evolution of AlxCrMnFeCoNi high-entropy alloys

High-rate superplasticity in an equiatomic medium-entropy VCoNi alloy enabled through dynamic recrystallization of a duplex microstructure of ordered phases

Effects of Heterogeneous Ultrafine Grain and Strain Rate on Mechanical Properties of CoCrNi Medium Entropy Alloy

Atomistic simulations of dislocation plasticity in concentrated VCoNi medium entropy alloys: Effects of lattice distortion and short range order

Exceptional high-strain-rate tensile mechanical properties in a CrCoNi medium-entropy alloy

Quasi-superplasticity in the AlCoNiV Medium Entropy Alloy with Heusler L21 Precipitates

Strain-rate-dependent behaviors of CoCrNiSi 0 . 2 medium-entropy alloy: Deformation mechanism and microstructural-based constitutive modeling

Achieving a Strength-Ductility Combination in Vconi Medium-Entropy Alloy Via N Alloying

Micromechanics reveal strain rate dependent transition between dislocation mechanisms in a dual phase high entropy alloy

Dynamic Mechanical Behavior and Microstructure of the Al 0.1 CoCrFeNiTi x High‐Entropy Alloys

Influence of ordered L12 precipitation on strain-rate dependent mechanical behavior in a eutectic high entropy alloy

A micromechanical study on the effects of precipitation on the mechanical properties of CoCrFeMnNi high entropy alloys with various annealing temperatures

Dynamic Shear Deformation of a CrCoNi Medium-Entropy Alloy with Heterogeneous Grain Structures

Molecular dynamics-based analysis of the effect of temperature and strain rate on deformation of nanocrystalline CoCrFeMnNi high-entropy alloy