Abstract:An equiatomic CoCrFeMnNi high-entropy alloy, which crystallizes in the face-centered cubic (fcc) crystal structure, was produced by arc melting and drop casting. The drop-cast ingots were homogenized, cold rolled and recrystallized to obtain single-phase microstructures with three different grain sizes in the range 4–160μm. Quasi-static tensile tests at an engineering strain rate of 10−3s−1 were then performed at temperatures between 77 and 1073K. Yield strength, ultimate tensile strength and elongation to fracture all increased with decreasing temperature. During the initial stages of plasticity (up to ∼2% strain), deformation occurs by planar dislocation glide on the normal fcc slip system, {111}〈110〉, at all the temperatures and grain sizes investigated. Undissociated 1/2〈110〉 dislocations were observed, as were numerous stacking faults, which imply the dissociation of several of these dislocations into 1/6〈112〉 Shockley partials. At later stages (∼20% strain), nanoscale deformation twins were observed after interrupted tests at 77K, but not in specimens tested at room temperature, where plasticity occurred exclusively by the aforementioned dislocations which organized into cells. Deformation twinning, by continually introducing new interfaces and decreasing the mean free path of dislocations during tensile testing (“dynamic Hall–Petch”), produces a high degree of work hardening and a significant increase in the ultimate tensile strength. This increased work hardening prevents the early onset of necking instability and is a reason for the enhanced ductility observed at 77K. A second reason is that twinning can provide an additional deformation mode to accommodate plasticity. However, twinning cannot explain the increase in yield strength with decreasing temperature in our high-entropy alloy since it was not observed in the early stages of plastic deformation. Since strong temperature dependencies of yield strength are also seen in binary fcc solid solution alloys, it may be an inherent solute effect, which needs further study.

Analysis of deformation behavior of VCoNi medium-entropy alloy at temperatures ranging from 77 K to 573 K

A Molecular Dynamics Study on Mechanical Performance and Deformation Mechanisms in Nanotwinned NiCo-based Alloys with Nano-Precipitates under High Temperatures

Liquid helium temperature deformation and local atomic structure of CoNiV medium entropy alloy

Real-time Nanoscale Observation of Deformation Mechanisms in CrCoNi-based Medium- to High-Entropy Alloys at Cryogenic Temperatures

Temperature Effects on Deformation Substructures and Mechanisms of a Ni-based Single Crystal Superalloy

Microstructural evolution and duplex structure-enhanced high-temperature mechanical properties of Al-doped VCoNi medium entropy alloy

Unraveling the Deformation Behavior of the Fe45Co25Ni10V20 High Entropy Alloy

Ultrahigh grain boundary strengthening ability of VCoNi medium entropy alloy

Dynamic precipitation-induced the negative strain rates sensitivity in VCoNi medium-entropy alloy

Real-time Atomic Deformation Behavior of Nano CoCrCuFeNi High-Entropy Alloy

Exceptional high-strain-rate tensile mechanical properties in a CrCoNi medium-entropy alloy

Temperature-dependent hardening contributions in CrFeCoNi high-entropy alloy

Martensitic transformation in CrCoNi medium-entropy alloy at cryogenic temperature

Molecular dynamics-based analysis of the effect of temperature and strain rate on deformation of nanocrystalline CoCrFeMnNi high-entropy alloy

Steady state flow of the FeCoNiCrMn high entropy alloy at elevated temperatures

Quasi-superplasticity in the AlCoNiV Medium Entropy Alloy with Heusler L21 Precipitates

Tensile Properties of a Non-Equiatomic Ni–Co–V Medium Entropy Alloy at Cryogenic Temperature

Deformation mechanisms of Al0.1CoCrFeNi at elevated temperatures

Extremely high dislocation density and deformation pathway of CrMnFeCoNi high entropy alloy at ultralow temperature

Effect of microstructure on temperature dependence of deformation behavior in polycrystalline CoNi-based superalloy

The influences of temperature and microstructure on the tensile properties of a CoCrFeMnNi high-entropy alloy