Abstract:In a high-temperature test of the gas generator with a free-loading composite propellant, an abnormal jitter appeared in the latter part of the internal ballistic curve, whereas no such abnormality was observed in the low-temperature and normal-temperature tests. To investigate the cause, quasi-steady-state simulations of the internal flow field, as well as strength and buckling simulations of the grain, were conducted. The strength simulation revealed that the maximum stress experienced by the composite propellant during operation at 323 K is 0.7 MPa, which is lower than the ultimate stress of the grain (1.01 MPa), indicating no stress failure. The buckling simulation demonstrated that the instability arises from an imbalance of pressure on the inner and outer surfaces of the grain. In the original structure, the ventilation effect on each surface of the grain varied with the regression of the burning surface, leading to a pressure imbalance on the inner and outer surfaces of the composite propellant. Consequently, a non-ablative cladding layer was applied to ensure that the ventilation effect of each channel remains constant. The simulation demonstrated that the pressure on the surfaces of the composite propellant gradually balanced with the operation of the gas generator. Upon retesting at high temperatures, no abnormal jitter was observed in the internal ballistic curve. This indicates that maintaining a constant ventilation area for the combustion chamber and preventing changes in the ventilation effect can ensure the structural integrity of the composite propellant during operation. The working state of the composite propellant with this non-ablative cladding layer is not affected by variations in the design of the solid rocket motor. This approach enhances the adaptability and reliability of the free-loading composite propellant under different motor structures.

A novel structure for improving the service life of a propulsion system by controlling two-phase reactive flow

A novel structure to inhibit barrel erosion induced by thermal effects in a propulsion system

Spray Swirling Flame Dynamic under Combined Modulation of Air and Fuel

Experimental and Numerical Study of a Two-Stage Swirl Burner

An Experimental Investigation of Groove Control for Reducing Drag in a Flat Turbulent Boundary Layer

Structure Optimization of Conical Spool and Flow Force Compensation in a Diverged Flow Cartridge Proportional Valve

Influence of Cyclone Combustor Structure on the Motion Behaviors of Solid Fuel Particles

Flow Force Analysis and Structural Optimization of a Large Flow Rate Pressure Compensation Valve

Numerical and Experimental Investigation on Opening Direction Steady Axial Flow Force Compensation of Converged Flow Cartridge Proportional Valve

Numerical Method of Propulsion Concept: Partially Cut Multiaperture Stick Propellant

Recoil Reduction Design of Gas-Controlled Side-Jet Gun Based on Bifurcated Two-Phase Flow Model

Study on unsteady combustion and propelling mechanism of modular charge based on Euler–Lagrange method

Dynamic Impact Deformation Characteristics of Multi-Layer Metallic Materials Based on a New Combustion Propulsion Pattern

Numerical simulation and optimized design of a launching system with a novel charge structure

Interior ballistic two-phase flow model and its calculation for a mixed charge structure

Evaluation of Mixing Effect on Coupled Heat Release and Transfer Performance of a Novel Segregated Solid Rocket Motor

Structural design of the fluted shaped charge liner using multi-section optimization method

Research on Solving the Structural Instability of Composite Propellants by Using Non-Ablative Cladding Layers

Numerical Simulation of Wall Liquid Film in Small Bipropellant Rocket Engine

Experimental Study on the Effect of Structural Geometry of “ablation Mode” Thruster on Propulsion Performance

Numerical analysis for two-phase flow in dual-thrust chamber with finocyl grain