Abstract:In a high-temperature test of the gas generator with a free-loading composite propellant, an abnormal jitter appeared in the latter part of the internal ballistic curve, whereas no such abnormality was observed in the low-temperature and normal-temperature tests. To investigate the cause, quasi-steady-state simulations of the internal flow field, as well as strength and buckling simulations of the grain, were conducted. The strength simulation revealed that the maximum stress experienced by the composite propellant during operation at 323 K is 0.7 MPa, which is lower than the ultimate stress of the grain (1.01 MPa), indicating no stress failure. The buckling simulation demonstrated that the instability arises from an imbalance of pressure on the inner and outer surfaces of the grain. In the original structure, the ventilation effect on each surface of the grain varied with the regression of the burning surface, leading to a pressure imbalance on the inner and outer surfaces of the composite propellant. Consequently, a non-ablative cladding layer was applied to ensure that the ventilation effect of each channel remains constant. The simulation demonstrated that the pressure on the surfaces of the composite propellant gradually balanced with the operation of the gas generator. Upon retesting at high temperatures, no abnormal jitter was observed in the internal ballistic curve. This indicates that maintaining a constant ventilation area for the combustion chamber and preventing changes in the ventilation effect can ensure the structural integrity of the composite propellant during operation. The working state of the composite propellant with this non-ablative cladding layer is not affected by variations in the design of the solid rocket motor. This approach enhances the adaptability and reliability of the free-loading composite propellant under different motor structures.

A novel structure to inhibit barrel erosion induced by thermal effects in a propulsion system

A novel structure for improving the service life of a propulsion system by controlling two-phase reactive flow

Simulation of ballistic performance of a two-layered structure of nanostructured metal and ceramic

A comparative study on gunpowder erosion and promoted ignition combustion of 30SiMn2MoV gun barrel

Research on the Erosion of Gun Barrel Based on Vented Vessel Tests

Preparation and performance studies on organic-inorganic phase change composites based on zeolitic imidazolate and paraffin for reducing gun barrel erosion

Finite element analysis of the friction and wear of the barrel bore during the projectile extrusion

Recoil Reduction Design of Gas-Controlled Side-Jet Gun Based on Bifurcated Two-Phase Flow Model

Super-High Initial Velocity Mechanism of Bullet Propulsion with Adaptive Pressure-Maintaining Chamber

Research on Vibration Control of Paired Inclined Nozzles Dynamic Coupled Tubes

Interior ballistic two-phase flow model and its calculation for a mixed charge structure

An Experimental Investigation of Groove Control for Reducing Drag in a Flat Turbulent Boundary Layer

Dynamic Modeling and Simulation of Gatling Gun with Muzzle Assistant-Rotating and Recoil Absorber

Research on Influence of Muzzle Brake Efficiency on Firing Density of Gatling Gun

Design and analysis of a scheme for the naval gun test shell entering the bore

Structure Optimization of Conical Spool and Flow Force Compensation in a Diverged Flow Cartridge Proportional Valve

Research on Solving the Structural Instability of Composite Propellants by Using Non-Ablative Cladding Layers

Experimental and Numerical Study On the Protection Efficiency of a Diamond-shaped Thermal Jacket for Gun Barrels

Modelling and experimental investigation of critical velocity and driving force for preventing smoke backlayering in a branched tunnel fire

Recoil Reduction Method of Gun with Side to Rear Jet Controlled by Piston Motion

The Construction of a Small-Caliber Barrel Wear Model and a Study of the Barrel Wear Rule