Abstract:Ni-Mn-Ga ferromagnetic shape memory alloys (FSMAs) have attracted great attention for more than two decades, due to their large magnetic shape memory effect that originates from the rearrangement of martensitic variants under an external magnetic field. Over the past decade, accumulated knowledge on the properties of Ni-Mn-Ga Heusler alloys has allowed people to foresee the possibility of employing these alloys in device applications. However, the low operating temperatures and high brittleness remain the major drawbacks for the industrial application. Consequently, there has been growing interest in the modification of Ni-Mn-Ga alloys by adding a fourth element to increase transformation temperatures and to improve ductility. A recent study shows that the ductility has been effectively improved in Cu-doped Ni-Mn-Ga alloy under the situation of single phase via strengthening grain boundaries. In addition, the crystal structure, martensitic transformation, magnetic properties, high temperature magnetoplasticity and magnetocaloric effect have been reported in Ni-Mn-Ga-Cu alloys. Experimental results have shown that the martensitic transformation temperature (T-m) is drastically increased and the Curie temperature (T-c) slightly decreased with Cu addition. As already known, the alloying elements affect both the crystal and electronic structures and hence the stability of austenite and martensite phases. Therefore, knowledge of the effects of Cu addition is of great importance to understand the composition dependence of T-m and T-c. First-principles calculation results on Ni8Mn4-xGa4Cux (x=0, 0.5, 1, 1.5 and 2) ferromagnetic shape memory alloys of this research draw following conclusions. The added Cu atom preferentially occupies the Mn site. The formation energy results indicate that ferromagnetic austenite is more stable than the paramagnetic one. The ferromagnetic state becomes instable and paramagnetic state becomes more stable when Mn is gradual substituted by Cu. The evaluated T-c decreases with increasing Cu content that is derived from the decrease of total energy difference between the paramagnetic and the ferromagnetic austenite. The experimentally observed decrease of T-m is originated from the decrease of total energy difference between the austenite and the non-modulated martensite. The difference between the up and down DOS is reduced with the increasing Cu content that gives rise to the decrease of the total magnetic moments. The purpose of this work is to explore the influence of Cu addition on crystal structure, T-m, T-c and electronic structures of Ni8Mn4-xGa4Cux (x=0, 0.5, 1, 1.5 and 2) alloys by first-principles calculations, aiming at providing theoretical data and directions for developing high performance FSMAs.

Magnetocrystalline anisotropy regulations in bulk L10-MnGa alloys by tailoring the tetragonal lattice parameter c: Selectively alloying Al and C atoms

Structure and tunable temperature coefficient of magnetization of Mn4-xGaxC alloys prepared by induction melting method

First-principles investigation of Mg substitution for Ga on martensitic transformation, magnetism and electronic structures in Ni2MnGa

Structural Evolution and Magnetic Properties of L10-type Mn54.5Al45.5-xGax (x = 0.0, 15.0, 25.0, 35.0, 45.5) Phase

Structural Properties and Large Coercivity of Bulk Mn3−xGa (0 ≤ X ≤ 1.15)

Origin of uniaxial magnetic anisotropy in MnAlCx: A first-principles study

Improved magnetostriction in Galfenol alloys by aligning crystal growth direction along easy magnetization axis

Microstructure and Magnetostrictive Performance of NbC-doped <100> Oriented Fe-Ga Alloys

A First-Principles Study on Crystal Structure, Phase Stability and Magnetic Properties of Ni-Mn-Ga-Cu Ferromagnetic Shape Memory Alloys

Tailoring the magneto-structural coupling in Mn1−xZrxCoGe alloys

Neutron-Diffraction Study of Hard Magnetic Alloy Mnalc

Recrystallization and magnetic hardening in Mn<inf>1.8</inf>Ga magnet by spark plasma sintering deformation

Effect of tetragonality on the magnetic preference, elasticity and magnetocrystalline anisotropy of L 1 0 -FeM(M = Ni, Pd, Pt) alloys

Ab Initio Determination of the Elastic Properties of Ferromagnetic Body-Centered Cubic Fe-Mn-Al Alloys

High-temperature properties and enhanced magnetic properties by magnetic field heat treatment of D0 22 Mn 3− x Ga (x = 0, 0.2, and 0.4) alloys

Tunable Magnetostructural Coupling and Large Magnetocaloric Effect in Mn1−Ni1−Fe2Si1−Ga

Magnetic phase transition and magneto-caloric effect (MCE) in (Mn0.5Ni0.5)60+Ga40- (x = 3.3, 5.0, and 6.6) alloys

Microstructure and magnetic properties of (Mn54Al46)98C2 magnets fabricated by liquid-phase sintering with the Mn65Ga35 as an additive

Tailoring Ferrimagnetic Transition Temperatures, Coercivity Fields, and Saturation Magnetization by Modulating Mn Concentration in (cocrfeni)1−x Mn X High-Entropy Alloys

Glassy Magnetic Transitions and Accurate Estimation of Magnetocaloric Effect in Ni–Mn Heusler Alloys

Tuning the Magnetic Transition and Magnetocaloric Effect in Mn1-Cr CoGe Alloy Ribbons