Abstract:Reasonable cutting edge preparation can eliminate microscopic defects and improve the performance of a cutting tool. The flexible fiber-assisted shear thickening polishing method was used for the preparation of cemented carbide insert cutting edge. The influences of the polishing angle and polishing speed on the cutting edge preparation process were investigated, and the cutting edge radius and K-factor were employed as evaluation indexes to evaluate the edge shape. A prediction model of the cutting edge radius was also established using the mathematical regression method. The results show that the polishing angle has a more significant effect on the cutting edge radius. The cutting edge preparation efficiency is the highest under the polishing angle of 10°, and the cutting edge radius increased from the 15 ± 2 μm to 110 ± 5 μm in 5 min. The cutting edge shape can be controlled by adjusting the polishing angle, and the K-factor varies from 0.14 ± 0.03 to 0.56 ± 0.05 under the polishing angle (from −20° to 20°). The polishing speed has a less effect on the cutting edge radius and shape, but increasing the polishing speed within a certain range can improve the efficiency of cutting edge preparation. The flank face roughness decreased from the initial Ra 163.1 ± 10 nm to Ra 5.2 ± 2 nm at the polishing angle of −20°, which is the best polishing angle for the flank face surface roughness. The ANOVA method was employed to evaluate the effective weight of the polishing angle and polishing speed on preparation efficiency. The polishing angle (86.79%) has the more significant influence than polishing speed (13.21%) on the cutting edge preparation efficiency. The mathematical regression method was used to establish the model of the prediction of the cutting edge radius with polishing angle and speed, and the models were proved rationally. The results indicate that the FF-STP is an effective method for the high consistency preparation of cemented carbide insert cutting edge.

Influence of cutting-edge radius by an edge-honing process on the cutting tool life and coating

Influence of Edge Preparation on Cutting Tool Wear

Study on the Orthogonal Cutting Process of Al7050T7451 with Uncoated and Coated Tools

Numerical Modeling of the Effect of Cutting-Edge Radius on Cutting Force and Stress Concentration during Machining

Enhancing the Machining Performance by Cutting Tool Surface Modifications: a Focused Review

Influence of Reground Tool Sharpness on Micro-Cutting Process

Analysis of Abrasives on Cutting Edge Preparation by Drag Finishing

Effects of Cutting Edge Radius on Surface Integrity in Machining of Nickel-Based Cast Superalloy: an in Situ Imaging Approach

The Factors Influencing on Cutting Edge Radius of Ultra-Precision Diamond Cutting Tools in Mechanical Lapping

Finite element simulation of cutting process under the worn tool edge geometries

Effect of Chamfered PCBN Tool Edge Geometries on Hard Turning Process

Simulation and Experimental Study on the Effect of Edge Radius on the Cutting Condition of Carbide Inserts

Mds Study On The Effect Of Cutting Edge Radius Of Diamond Tools In Nanometric Cutting Process For Brittle Materials

Analyzing the effect of cutting parameters and tool nose radius on forces, machining power and tool life in face milling of ductile iron and validation using finite element analysis

Preparation of Cemented Carbide Insert Cutting Edge by Flexible Fiber-Assisted Shear Thickening Polishing Method

Numerical Investigation on the Effect of Cutting-Edge Shape Factor on the Cutting Performance of Titanium Alloy

Investigation on Cutting Performance of Micro-Textured Cutting Tools

Modelling the Effects of Tool Edge Radius on Micro Machining Based on Smooth Particle Hydrodynamics Simulation Method

Enhancement of micro milling performance by abrasion-resistant coated tools with optimized thin-film thickness: analytical and experimental characterization

Influence of cutting parameters on PCD tool wear during milling tungsten carbide

Cutting Performance of Different Coated Micro End Mills in Machining of Ti-6Al-4V