Abstract:Economic viability of small launch vehicles, i.e., microlaunchers, is impaired by several factors, one of which is a higher dry to wet mass ratio as compared to conventional size launchers. Although reusability may reduce launch cost, it can drive dry and/or wet mass to unfeasibly high levels. In particular, for load-bearing components that are exposed to convective heating during the aerothermodynamic phase of the re-entry, the mass increase due to the presence of a thermal protection system (TPS) must be considered. Examples of such components are aerodynamic drag devices (ADDs), which are extended during the re-entry. These should withstand high mechanical loading, be thermally protected to avoid failure, and be reusable. Ablative materials can offer lightweight thermal protection, but they represent an add-on mass for the structure and they are rarely reusable. Similarly, TPS based on ceramic matrix composite (CMC) tiles represent an additional mass. To tackle this issue, so-called integrated thermal protection systems (ITPS) composed of CMC sandwich structures were introduced in the literature. The aim is to obtain a load-bearing structure that is at the same time the thermally protective layer. However, a comprehensive description of the real lightweight potential of such solutions compared to ablative materials with the corresponding sub-structures is, to the authors' knowledge, not yet presented. Thus, based on the design of an ADD, this work aims to holistically describe such load bearing components and to compare different TPS solutions. Both thermal and preliminary mechanical designs are discussed. Additionally, a novel concept is proposed, which is based on the use of phase change materials (PCMs) embedded within a metallic sandwich structure with an additively manufactured lattice core. Such a solution can be beneficial due to the combination of both the high specific stiffness of lattice structures and the high mass-specific thermal energy storage potential of PCMs. The study is conducted with reference to the first stage of the microlauncher analysed within the European Horizon-2020 project named Recovery and Return To Base (RRTB).

Platelet based Active Thermal Protection System (ATPS)

New-typed ARMOR Thermal Protection Systems

Comprehensive Comparison of Different Integrated Thermal Protection Systems with Ablative Materials for Load-Bearing Components of Reusable Launch Vehicles

Improved Metallic Thermal Protection Systems for Reentry Vehicles: Thermomechanical and Impact Considerations

Thermo-mechanical Analysis of a Multilayer Hollow Cylindrical Thermal Protection Structure with Functionally Graded Ultrahigh-Temperature Ceramic to Be Heat Resistant Layer

Analysis and Design of Metallic Thermal Protection Systems for Reusable Launch Vehicle

Evaluation of Reusable Thermal Protection System Materials Using a High-Velocity Oxygen Fuel Torch

Selection of Materials and Design of Multilayer Lightweight Passive Thermal Protection System

Thermal Protection System Requirements for Future Planetary Entry and Aerocapture Missions

A novel mechanical-thermal-electrical thermal protection system concept and its multi-scale performance evaluation for hypersonic launch vehicles

Low Density Syntactic Foam Composites as Ablative TPS Material for High Heat Flux Conditions for Reentry Missions

Applied-Field Magnetoplasmadynamic Thrusters for Deep Space Exploration

Present status and future prospects of plasma sprayed multilayered thermal barrier coating systems

Design and Efficiency Assessment of Hybrid Thermal Protection Structures for Return Capsule Reentry

Finite Element Analysis of Metallic Thermal Protection Systems Design

Practical Aspects of Suspension Plasma Spray for Thermal Barrier Coatings on Potential Gas Turbine Components

Research on new materials of metallic thermal protection system panel for reusable launch vehicle

Topology Optimisations for Integrated Thermal Protection Systems Considering Thermo-Mechanical Constraints

Thermal Fatigue of Atmospheric Plasma Sprayed Thermal Barrier Coatings

System Analysis and Test-Bed for an Atmosphere-Breathing Electric Propulsion System using an Inductive Plasma Thruster

Multilayer Thermal Barrier Coatings: Interplay among Coating Design, Processing and Properties