Abstract:Economic viability of small launch vehicles, i.e., microlaunchers, is impaired by several factors, one of which is a higher dry to wet mass ratio as compared to conventional size launchers. Although reusability may reduce launch cost, it can drive dry and/or wet mass to unfeasibly high levels. In particular, for load-bearing components that are exposed to convective heating during the aerothermodynamic phase of the re-entry, the mass increase due to the presence of a thermal protection system (TPS) must be considered. Examples of such components are aerodynamic drag devices (ADDs), which are extended during the re-entry. These should withstand high mechanical loading, be thermally protected to avoid failure, and be reusable. Ablative materials can offer lightweight thermal protection, but they represent an add-on mass for the structure and they are rarely reusable. Similarly, TPS based on ceramic matrix composite (CMC) tiles represent an additional mass. To tackle this issue, so-called integrated thermal protection systems (ITPS) composed of CMC sandwich structures were introduced in the literature. The aim is to obtain a load-bearing structure that is at the same time the thermally protective layer. However, a comprehensive description of the real lightweight potential of such solutions compared to ablative materials with the corresponding sub-structures is, to the authors' knowledge, not yet presented. Thus, based on the design of an ADD, this work aims to holistically describe such load bearing components and to compare different TPS solutions. Both thermal and preliminary mechanical designs are discussed. Additionally, a novel concept is proposed, which is based on the use of phase change materials (PCMs) embedded within a metallic sandwich structure with an additively manufactured lattice core. Such a solution can be beneficial due to the combination of both the high specific stiffness of lattice structures and the high mass-specific thermal energy storage potential of PCMs. The study is conducted with reference to the first stage of the microlauncher analysed within the European Horizon-2020 project named Recovery and Return To Base (RRTB).

Selection of Materials and Design of Multilayer Lightweight Passive Thermal Protection System

Thermo-mechanical Analysis of a Multilayer Hollow Cylindrical Thermal Protection Structure with Functionally Graded Ultrahigh-Temperature Ceramic to Be Heat Resistant Layer

Heat transfer and pyrolysis gas flow characteristics of light-weight ablative thermal protection system in the blunt body

Comprehensive Comparison of Different Integrated Thermal Protection Systems with Ablative Materials for Load-Bearing Components of Reusable Launch Vehicles

Finite Element Analysis of Metallic Thermal Protection Systems Design

Evaluation of Reusable Thermal Protection System Materials Using a High-Velocity Oxygen Fuel Torch

Analysis and Design of Metallic Thermal Protection Systems for Reusable Launch Vehicle

Improved Metallic Thermal Protection Systems for Reentry Vehicles: Thermomechanical and Impact Considerations

Flow Mechanics in Ablative Thermal Protection Systems

Low Density Syntactic Foam Composites as Ablative TPS Material for High Heat Flux Conditions for Reentry Missions

Experimental and Numerical Analysis of Integrated Thermal Protection System

Ablation simulation of integral woven gradient three‐dimensional thermal protection structures for planetary exploration

Platelet based Active Thermal Protection System (ATPS)

Design of ablation resistant/heat insulation/lightweight integrated thermal protection material for extreme aerothermodynamic environment

Evaluation method and key factor analysis for thermal protection performance of multifunctional integrated ablative materials

Thermal-Acoustic Fatigue of a Multilayer Thermal Protection System in Combined Extreme Environments

A novel mechanical-thermal-electrical thermal protection system concept and its multi-scale performance evaluation for hypersonic launch vehicles

Significantly Enhanced Mechanical, Thermal, and Ablative Properties of the Lightweight Carbon Fabric/Phenol-Formaldehyde Resin/Siloxane Aerogels Ternary Interpenetrating Network

Numerical Analysis on Thermal Stress of Multilayer Materials Combined Structures for a Lightweight Thermal Protection System

Design and Heat Transfer Analysis of a Compound Multi-Layer Insulations for Use in High Temperature Cylinder Thermal Protection Systems

Thermomechanical Performance of Bio-Inspired Corrugated-Core Sandwich Structure for a Thermal Protection System Panel