Abstract:Cloud-point curves of blends of poly(methyl methacrylate) (PMMA) with a series of oligodiols based on a bisphenol A nucleus and short branches of poly(ethylene oxide) or poly(propylene oxide) (BPA-EO or BPA-PO), and with PEO and PPO oligomers, were obtained using a light transmission device. Experimental results were fitted with the Flory- Huggins model using an interaction parameter depending on both temperature and composition. For PMMA/PEO and PMMA/PPO blends, the miscibility increased when increasing the size of the diol, due to the significant decrease in the entropic and enthalpic terms contributing to the interaction parameter. This reflected the decrease in the selfassociation of solvent molecules and in the contribution of terminal OH groups to the mismatching of solubility parameters. For PMMA/BPA-EO blends, a decrease of the entropic contribution to the interaction parameter when increasing the size of the oligodiol was also found. However, the effect was counterbalanced by the opposite contribution of combinatorial terms leading to cloud-point curves located in approximately the same temperature range. For PMMA/BPA-PO blends, the interaction parameter exhibited a very low value. In this case, the effect of solvent size was much more important on combinatorial terms than on the interaction parameter, leading to an increase in miscibility when decreasing the oligodiol size. For short BPA-PO oligodiols no phase separation was observed. The entropic contribution of the interaction parameter exhibited an inverse relationship with the size of the oligodiols, independent of the nature of the chains bearing the hydroxyls and the type of OH groups (primary or secondary). This indicates that the degree of self-association of solvent molecules through their OH terminal groups, was mainly determined by their relative sizes.

Miscibility of Non‐Uniform Aliphatic Polyamide Mixtures

Crystal Polymorphism and Phase Transition of Isodimorphic Copolyamides Based on Even–Even and Odd–Even Comonomer Units: Synergistic Effects of Copolymer Composition and Crystallization Temperature

Rheological Properties of PET/PA66/Liquid Crystalline Copolyesteramide Blends

Monte Carlo simulation of molecular weight distribution and copolymer composition in transamidation reaction of polyamides

A Dissipative Particle Dynamics Study on the Compatibilizing Process of Immiscible Polymer Blends with Graft Copolymers

Synergetic Effect of a Reactive Compatibilizer and Organo-montmorillonite on the Dispersion of Polyamide 6 /Polydimethylsilicone Blend with a High Viscosity Ratio

Composition dependent miscibility in the crystalline state of polyamide 6 /polyamide 4,10 blends: From single to double crystalline blends

The Preparation of Monomer Casting Polyamide 6/Thermotropic Liquid Crystalline Polymer Composite Materials with Satisfactory Miscibility

A Miscibility Study of p(MMA- co-HEMA)-Based Polymer Blends by Thermal Analysis and Solid-State NMR Relaxometry

Molecular Compatibility of Polyamide 6 Blending with Thermal Liquid Crystalline Polyamide

Rheological Property Modification of a Molten-State Polyamide through the Addition of an α-Olefin–Maleic Anhydride Copolymer

Effect of composition distribution on miscibility and co-crystallization phenomena in the blends of low density polyethylene with conventional and metallocene-based ethylene–butene copolymers

Crystallization and Performance of Polyamide Blends Comprising Polyamide 4, Polyamide 6, and Their Copolymers

Morphology Evolution of Miscible Blends Between Crystalline Pa6 and Amorphous Pa6icot

Hydrogen Bond Mediated Partially Miscible Poly(n-Acryloyl Piperidine)/poly(acrylic Acid) Blend with One Glass Transition Temperature

Compatibilization And Toughening Of Immiscible Ternary Blends Of Polyamide 6, Polypropylene (Or A Propylene-Ethylene Copolymer), And Polystyrene

Analysis of phase morphology and dynamics of immiscible PP/PA1010 blends and its partial-miscible blends during melt mixing from SEM patterns

Investigation of Water Diffusion Mechanisms in Relation to Polymer Relaxations in Polyamides

Miscibility of blends of poly(methyl methacrylate) and oligodiols based on a bisphenol A nucleus and ethylene oxide or propylene oxide branches

Synthesis and characterizations of random copolyamide PA(56- co -66): Excellent toughness and transparency

Miscibility and Morphology of AB/C‐type Blends Composed of Block Copolymer and Homopolymer or Random Coploymer, 2. Blends with Random Copolymer Effect