Abstract:For coal semi-char as a by-produced of low-temperature pyrolysis, combustion for power generation is one of the effective utilization methods to realize its clean and efficient utilization. However, the coal semi-char combustion process has a difficult ignition, unstable combustion and low burnout rate. The co-firing of the semi-char with biomass under oxy-fuel conditions can improve the combustion behavior and reduce fossil CO2 emissions. In this paper, the combustion behavior of Shenhua coal semi-char (SHC) co-firing with straw (ST) in O2/CO2 mixture is investigated using thermogravimetric analysis. The results show that each curve lays between those of the individual fuels and presents three peaks (i.e., three stages). The thermogravimetric curves of SHC co-firing with ST can be divided into three stages: the volatile combustion of ST, the co-combustion of SHC and ST fixed-carbons and the SHC fixed-carbon combustion and the decomposition of the difficult pyrolytic material of ST. Blending ST into the SHC can significantly decrease the ignition temperature and improve the comprehensive combustion behavior of blended samples. In increasing the proportion of ST from 25 to 100%, the change of the blended ignition temperature is slight, but the burnout temperature decreases greatly. Kinetic parameters of combustion are calculated by using the Coats–Redfern integral method. Compared to that of stage I and stage III, the activation energy of stage II is significantly lower. As increasing blending ratio from 25% to 100%, the activation energy increases at stage I and decreases at stage III. Furthermore, the O2 concentration obviously affects stage III of 50% SHC + 50% ST, and the thermogravimetric curves at this stage are obviously shifted to the lower temperature zone as the O2 concentration increases. The activation energy of 50% SHC + 50% ST increases as the oxygen concentration increases. Besides, the activation energy shows that the combustion characteristics cannot be determined only by the activation energy obtained by the Coats–Redfern method. These findings can provide useful information for semi-char co-firing with biomass.

Thermogravimetric characteristics of corn straw and bituminous coal co-pyrolysis based the ilmenite oxygen carriers

Gas Emissions from Blends of Bituminous Coal and Biomass Chars under Different Pyrolysis Conditions

Studies on the synergistic effect between corn straw and Canadian oil sands bitumen during the co-pyrolysis process

Infrared heating and synergistic effects during fast co-pyrolysis of corn stover and high alkali coal

Thermal Behavior and Gas Evolution Characteristics During Co-Pyrolysis of Lignocellulosic Biomass and Coal: A TG-FTIR Investigation

Kinetic Study on Co-Combustion of Pulverized Anthracite and Bituminite for Blast Furnace Injection

Thermogravimetric Analysis and Kinetics of the Co-Pyrolysis of Coal Blends with Corn Stalks

Influence of Coal Ash on the Characteristics of Corn Straw Pyrolysis Products.

Thermogravimetric Analysis of Coal Semi-Char Co-Firing with Straw in O2/CO2 Mixtures

Non-isothermal Thermogravimetric Investigation on Mutual Effect Between Bituminite and Anthracite in Blends for Blast Furnace Injection

Co-combustion of Coal and Carbonaceous Wastes: Thermogravimetric Analysis

The Thermal Behavior and Kinetics of Co-Combustion Between Sewage Sludge and Wheat Straw

Interactions between corncob and lignite during temperature-programmed co-pyrolysis

Experimental study on co-firing characteristics of coal/biomass blends in O2/CO2 atmosphere

Investigation of the synergistic effect and kinetic behavior of anthracite and biochar during co-combustion process in pure oxygen atmosphere

Product Characteristics and Interaction Mechanism in Low-Rank Coal and Coking Coal Co-Pyrolysis Process

Physicochemical characteristics of biomass‐coal blend char: The role of co‐pyrolysis synergy

Co-Combustion Characteristics of Typical Biomass and Coal Blends by Thermogravimetric Analysis

Thermal coupling study during the co-processing of coal and biomass in the lab-scale adiabatic reactor

Co-pyrolysis of biomass and polyethylene: Mechanistic insights into functional group transformations on solid matrix

Co-Pyrolysis Characteristics of Coal and Sludge Blends Using Thermogravimetric Analysis