Abstract:This study examined the co-pyrolysis characteristics of low-rank coal (SJC) and direct coal liquefaction residue (DCLR) through thermogravimetric analysis coupled with Fourier transform infrared spectrometry. It also investigated the influences of different mass fractions of DCLR to SJC on the co-pyrolysis characteristics and release regulation of gas phase components. Results showed that with increasing DCLR content, coke yield initially decreased and then increased, but tar and gas yield reversed. Different addition of DCLR changed the composition of the pyrolysis gas in various degrees, and reduced the content of-OH and nitrogen compounds in coke. The H 2 content in the gas gradually increased. When 40% DCLR was added, the maximum tar yield was 22.79%, and the maximum H 2 yield was 37.12%. At 60% DCLR, the lowest semi-coke yield was 65.01%, and the highest gas yield was 14.65%. The co-pyrolysis of SJC and DCLR can be divided into three stages. The first was the dry degassing stage, during which the adsorbed gas and small-molecule gas were removed on the coal surface at room temperature to 350 °C. The second stage (350 °C–650 °C) was the intense pyrolysis reaction stage, during which a large number of volatiles were obtained. The substantial weight loss rate peak appeared around 450 °C. The weight loss rate of pyrolysis gradually increased with increasing DCLR dosage. The co-pyrolysis of SJC and DCLR was not a simple sum between SJC and DCLR, which indicated a synergistic effect in the co-pyrolysis. The synergistic effect between SJC and DCLR enhances the interaction between free-radical fragments, thereby increasing the yield of pyrolysis tar. The third stage was the shrinkage of semi-coke from 650 °C to the end of the reaction. The polycondensation reaction between free-radical fragments to form solid coke with higher aromaticity, and H 2 released.

Co-Pyrolysis Characteristics of Coal and Sludge Blends Using Thermogravimetric Analysis

Sludge Acts As a Catalyst for Coal During the Co-Combustion Process Investigated by Thermogravimetric Analysis

Thermogravimetric Analysis and Kinetics of the Co-Pyrolysis of Coal Blends with Corn Stalks

Co-combustion of Coal and Carbonaceous Wastes: Thermogravimetric Analysis

Synergistic effects on co-pyrolysis and co-combustion of sludge and coal investigated by thermogravimetric analysis

Thermogravimetric analysis of the co-combustion of coal and paper mill sludge

Gas Emissions from Blends of Bituminous Coal and Biomass Chars under Different Pyrolysis Conditions

The Thermal Behavior and Kinetics of Co-Combustion Between Sewage Sludge and Wheat Straw

Thermal Behavior and Gas Evolution Characteristics During Co-Pyrolysis of Lignocellulosic Biomass and Coal: A TG-FTIR Investigation

Co-combustion characteristics and kinetics of sludge/coal blends in 21%–50% oxygen-enriched O 2 /CO 2 atmospheres

Effects of Direct Coal Liquefaction Residue Additions on Low-Rank Pulverized Coal during Co-Pyrolysis

Combustion characteristics of sewage sludge,coal water slurry and sludge-CWS mixtures by thermo gravimetric analysis

Co-pyrolysis of sewage sludge and low-density polyethylene – A thermogravimetric study of thermo-kinetics and thermodynamic parameters

Co-pyrolysis Behavior of Coal and Biomass: Synergistic Effect and Kinetic Analysis

Thermo-gravimetric Analysis and Co-Combustion Characteristics of Dried Sludge and Coal.

Co-pyrolysis behaviors, kinetics, and thermodynamics of sludge, lignite and biomass through fixed-bed reactor experiments and thermogravimetric analysis

Co-combustion Characteristics and CO2 Emissions of Low-Calorific Multi-Fuels by TG-FTIR Analysis

Investigation of co-pyrolysis characteristics of modified coal gangue and biomass

Co-pyrolysis characteristics and synergistic mechanism of low-rank coal and direct liquefaction residue

Study of co-pyrolysis kinetics, synergetic effects, and thermodynamics of coal and biomass blends

Investigation of kinetics, reaction mechanisms, thermodynamics, and synergetic effects in co-pyrolysis of wood sawdust and linear low-density polyethylene using the thermogravimetric approach