Abstract:Two major challenges in fluid bed combustion of biomass are increased NOX emissions and bed agglomeration. Different additives were employed to simultaneously reduce NOX emissions and bed agglomeration from the fluidized bed combustion of biomass. The base fuel was straw, and the additives included CaO, kaolin, MgCO3, coal fly ash, clay, (NH4)2Fe(SO4)2, NH4Fe(SO4)2, (NH4)2SO4, NH4MgPO4, AlNH4(SO4)2, (NH4)2HPO4, (NH4)3[Fe(C2O4)3], and urea. The influence of (NH4)2SO4 particle size (<35 and <106 μm) and introduction method (batch addition or premixing with fuel) was additionally investigated. The most effective additives against NOX emissions and bed agglomeration were further studied in air staged straw combustion and unstaged sunflower husk combustion. During sunflower husk combustion, the influence of ash accumulation and incipient defluidization on NOX emissions were examined. The results show that kaolin, CaO, MgCO3, (NH4)2Fe(SO4)2, NH4Fe(SO4)2, AlNH4(SO4)2, and NH4MgPO4 prevented defluidization during straw combustion under the investigated conditions. Of these, AlNH4(SO4)2 and NH4MgPO4 reduced the fuel-N to NO conversion by 40%. The mechanism of reduction was related to the facilitation of thermal DeNOX reactions by the introduction of NH3-releasing additives. However, the NH-based additives resulted in higher emissions of N2O. The size of (NH4)2SO4 particles had a slight influence on the defluidization tendency and nitrogen chemistry, while no significant difference was observed between the two additive introduction methods. Air staging reduced the fuel-N to NO conversion by 40% during straw combustion. The use of NH4MgPO4 and AlNH4(SO4)2 under air staged conditions increased the NO emission slightly. This was predominantly caused by the combustion of NH3 in the secondary air jet. In the case of unstaged sunflower husk combustion, NH4MgPO4 and AlNH4(SO4)2 prevented defluidization while reducing the conversion of fuel-N to NO by 30%. During sunflower husk combustion, the accumulation of ash increased NO and decreased NH3 concentrations above the bed. This was related to the poor mixing as the bed approached defluidization and to the catalytic effect of ash forming elements on the oxidation of NH3 to NO.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.energyfuels.1c01186?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.energyfuels.1c01186</a>.Information on axial reactor temperature profiles, Experiment repeatability, TGA of de-NOX additives, CO and CXHY local concentrations, pressure drop across bed during sunflower husk combustion, and figures of temperature profiles, axial NO, N2O, NH3, and CO profiles, weight loss data, decomposition products, axial CH2O, CH4, C3H6, C3H8, C2H2, C2H4, C2H6, SO2, SO3, and H2SO4 profiles, and pressure drop (<a class="ext-link" href="/doi/suppl/10.1021/acs.energyfuels.1c01186/suppl_file/ef1c01186_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Ilmenite as alternative bed material for the combustion of coal and biomass blends in a fluidised bed combustor to improve combustion performance and reduce agglomeration tendency

Ash Properties of Ilmenite Used as Bed Material for Combustion of Biomass in a Circulating Fluidized Bed Boiler

Improvement of Coal and Petroleum Coke Combustion in a Fluidized Bed by Using Ilmenite Ore As Bed Material

Fluidised bed combustion and ash fusibility behaviour of coal and spent coffee grounds blends: CO and NOx emissions, combustion performance and agglomeration tendency

Using Ilmenite To Reduce the Tar Yield in a Dual Fluidized Bed Gasification System

The impact of aluminosilicate-based additives upon the sintering and melting behaviour of biomass ash

Inhibition of Lignite Ash Slagging and Fouling Upon the Use of a Silica-Based Additive in an Industrial Pulverised Coal-Fired Boiler: Part 3 – Partitioning of Trace Elements

Ash Deposition Behaviours Upon the Combustion of Low-Rank Coal Blends in a 3 MWth Pilot-Scale Pulverised Coal-Fired Furnace

Continuous Test of Ilmenite-Based Oxygen Carriers for Chemical Looping Combustion in a Dual Fluidized Bed Reactor System

Investigation on self-sustained combustion, NOx emissions, and ash characteristics of coal slime in a lab-scale fluidized bed

Inhibition of Lignite Ash Slagging and Fouling Upon the Use of a Silica-Based Additive in an Industrial Pulverised Coal-Fired Boiler. Part 1. Changes on the Properties of Ash Deposits along the Furnace

Bed Agglomeration Problems in Fluidized-Bed Biomass Combustion

Investigation into scavenging of sodium and ash deposition characteristics during co-combustion of Zhundong lignite with an oil shale semi-coke of high aluminosilicate in a circulating fluidized bed

NOx Emission from a Circulating Fluidized Bed Boiler Cofiring Coal and Corn Stalk Pellets

Pollutant Emission and Attrition Performance of Low Calorific Blended Coals During Co-Combustion in Fluidized Bed

Multifunctional Additives for NO X Abatement in Fluidized Bed Biomass Combustion

Oxygen-Carrier-Aided Combustion in a Bench-Scale Fluidized Bed

Coal-Scenedesmus Microalgae Co-Firing in a Fixed Bed Combustion Reactor: A Study on CO2, SO2 and NOx Emissions and Ash

Reduction kinetics of foreign-ion-promoted ilmenite using carbon monoxide (CO) for chemical looping combustion

Fate and Abatement of Mercury and Other Trace Elements in a Coal Fluidised Bed Oxy Combustion Pilot Plant