Abstract:Fabrication and organosilane-functionalization and characterization of nanostructured ITO electrodes are reported. Nanostructured ITO electrodes were obtained by electron beam evaporation, and a subsequent annealing treatment was selectively performed to modify their crystalline state. An increase in geometrical surface area in comparison with thin-film electrodes area was observed by atomic force microscopy, implying higher electroactive surface area for nanostructured ITO electrodes and thus higher detection levels. To investigate the increase in detectability, chemical organosilane-functionalization of nanostructured ITO electrodes was performed. The formation of 3-glycidoxypropyltrimethoxysilane (GOPTS) layers was detected by X-ray photoelectron spectroscopy. As an indirect method to confirm the presence of organosilane molecules on the ITO substrates, cyclic voltammetry and electrochemical impedance spectroscopy (EIS) were also carried out. Cyclic voltammograms of functionalized ITO electrodes presented lower reduction-oxidation peak currents compared with non-functionalized ITO electrodes. These results demonstrate the presence of the epoxysilane coating on the ITO surface. EIS showed that organosilane-functionalized electrodes present higher polarization resistance, acting as an electronic barrier for the electron transfer between the conductive solution and the ITO electrode. The results of these electrochemical measurements, together with the significant difference in the X-ray spectra between bare ITO and organosilane-functionalized ITO substrates, may point to a new exploitable oxide-based nanostructured material for biosensing applications. As a first step towards sensing, rapid functionalization of such substrates and their application to electrochemical analysis is tested in this work. Interestingly, oxide-based materials are highly integrable with the silicon chip technology, which would permit the easy adaptation of such sensors into lab-on-a-chip configurations, providing benefits such as reduced size and weight to facilitate on-chip integration, and leading to low-cost mass production of microanalysis systems.

Study on the accuracy of Indium-Tin-Oxide (ITO) nanoparticle sensor based on solvent detection characteristics in water

Detection Of Trace Nitroaromatic Isomers Using Indium Tin Oxide Electrodes Modified Using Beta-Cyclodextrin And Silver Nanoparticles

In(OH)3particles from an Ionic Liquid Precursor and Their Conversion to Porous In2O3particles for Enhanced Gas Sensing Properties

Unusually Flexible Indium(III) Metal-Organic Polyhedra Materials for Detecting Trace Amounts of Water in Organic Solvents and High Proton Conductivity.

Investigation of ITO based liquid sensor for ammonia hydroxide detection

Polyaniline–TiO2 Nano-Composite-based Trimethylamine QCM Sensor and Its Thermal Behavior Studies

A Microgap Impedance Sensor for the Determination of Trace Water in Organic Solvents

Isopropanol sensor based on sprayed In2S3 thin film using linear discriminant analysis for real-time selectivity

Rapid Detection of Taste and Odor Compounds in Water Using the Newly Invented Chemi-Ionization Technique Coupled with Time-of-flight Mass Spectrometry.

High-performance ethanol sensor based on In2O3 nanospheres grown on silicon nanoporous pillar array

Pen plotter printing of ITO thin film as a highly CO sensitive component of a resistive gas sensor

Organosilane-functionalization of nanostructured indium tin oxide films

ZnO nanowires grown on SOI CMOS substrate for ethanol sensing

Optical performance of Tin doped Indium Oxide (ITO) thin films prepared by sol gel dip coating techniques using acrylamide route

Mesoporous sieve structured ITO-based thin films for enhanced formaldehyde detection

Thin Indium-Tin-Oxide Film Produced Through Sol–Gel Method with Its Morphological and Electrical Properties

Determination of low solvent concentration by nano-porous silicon photonic sensors using volatile organic compound method

The effect of various solvents on the back channel of solution-processed In–Ga–Zn–O thin-film transistors intended for biosensor applications

Accurate Single-Molecule Indicator of Solvent Effects

Verification of performance with the automated direct optical TIRF immunosensor (River Analyser) in single and multi-analyte assays with real water samples

Nanoscale carbon dot-embedded metal–organic framework for turn-on fluorescence detection of water in organic solvents