Abstract:In this work, based on the sol-gel method combined with spray granulation technology, a novel process method to prepare Yttria stabilized ZrO2 beads with 5–50 µm diameter, 123 nm grains size, few pores, solid internal structure and well spherical type is proposed. These advantages can greatly improve the beads density, and decline the sintering temperature. The optimum preparation parameters, including sol and spray parameters, baking and sintering conditions, are obtained through the investigation of experimental conditions. The SEM test results of the surface and cross section morphologies show that the beads have solid structure and there is good consistency between the surface and interior of the beads. The average grain size of test results is about 123 nm. The XRD test results demonstrate that no monoclinic phase exists in the beads. The sintering temperature of the new process is only 1200 °C. In this work, based on the sol-gel method combined with spray granulation technology, a novel process method to prepare Yttria stabilized ZrO2 beads with 5–50 µm diameter, 123 nm grains size, few pores, solid internal structure and well spherical type is proposed. These advantages can greatly improve the beads density, and decline the sintering temperature. The processes of the method mainly contain: sol preparation, spray forming process, organic compound discharging and sintering. The optimum preparation parameters, including sol and spray parameters, baking and sintering conditions, are obtained through the investigation of experimental conditions. The tested density result of the prepared beads is about 6.024 g/cm3 which is higher than for the traditional process. The SEM test results show that the diameter of the prepared Yttria stabilized ZrO2 beads is range from 5 to 50 µm with good sphericity. The surface and cross section morphologies show that the beads have solid structure and there is good consistency between the surface and interior of the beads. The average grain size is about 123 nm, no pores between grains. The XRD test results demonstrate that no monoclinic phase exists in the beads. The sintering temperature of the new process is only 1200 °C.

Novel dry-suspension granulation process for preparing pressed powders of ceramic tiles

A novel dry granule preparation technology and comparison of granule properties with conventional wet system for ceramic tiles production

Preparation of ZrO2 microspheres by spray granulation

Surface Treatment and Modification of Al2O3 Powders

Systematic optimization of spray drying for YAG transparent ceramics

RESEARCH PROGRESS OF NEW COLLOIDAL FORMING PROCESSES FOR ADVANCED CERAMICS

Preparation and Characterization of Monodispersed and Spherical YAG Powder for Transparent Ceramic by Spray Drying

Research Development of Ceramics Slurry in the Wet Forming Process

Chemical vapor processing and applications for nanostructured ceramic powders and whiskers

Processing and Characterization of Ceramic Powders

Current and Future of Dry Centrifugal Granulation Process

Characterization of Spray Granulated Nd:Yag Particles for Transparent Ceramics

PVB Modified Spherical Granules of Β-Tcp by Spray Drying for 3D Ceramic Printing

Rheological properties and spray-drying behaviors of nano-SiC based aqueous slurry

Fast Uniform Mixing & Controllable Colloidal Forming of Ceramics

Novel process of preparation of Yttria stabilized ZrO2 small sizes beads using sol-gel method combined with spray granulation technology

Proposition of a robot-based free diamond abrasive grinding process and its influence on the characteristics of plasma-sprayed 8YSZ coatings

Preparation of spherical zirconia powder by nano-reactor of microemulsion and its densification behavior

Spray Freeze Granulation of Submicron Alumina and Its Sintering Behavior Via Spark Plasma Sintering

Energy saving from furnace slag: Study on centrifugal granulation characteristics of the rotating cup

Centrifugal granulation behavior in metallic powder fabrication by plasma rotating electrode process