Abstract:The enhancement in selectivity of nanofiltration (NF) membranes is of great significance for extending the application areas and improving the process economy, especially for the separation of monovalent/divalent ions. The characteristics of moderately increased pore size, fewer nonselective defects and a more uniform structure are conducive to NF membrane exhibiting higher rejection of divalent ions but lower rejection of monovalent ions. Nonylphenol polyoxyethylene ether (NP-10) was introduced in interfacial polymerization process in this study to optimize the microstructure and surface properties of polyamide (PA) layer to manufacture highly selective NF membranes. The hydrophobic benzene ring and aliphatic chain in NP-10 could form a local space that restricted the interfacial polymerization reaction on the side of the oil phase, thereby appropriately increasing the pore size of the PA layer. It was advantageous to the permeation of water molecules and monovalent ions with a smaller radius. The long hydrophilic oxyethylene group as a guide could facilitate the uniform diffusion of the monomer to the water/hexane interface. NP-10 as an amphiphilic substance would form a self-assembled network at the water/hexane interface, which was expected to optimize the distribution of aqueous amine monomers at the phase interface. Meanwhile, introducing NP-10 can form a stable interface and reduce the interface disturbance, thus inhibiting the formation of non-selective macropores (or “defects”) in PA layer, which could improve the separation selectivity of monovalent/divalent ions. In addition, the hydrophilicity and electronegativity were also enhanced. The results showed that the MWCO of NF membrane increased from 210.1 Da (TFC-0) to 269.6 Da (TFC-0.25), and the average pore radius increased from 0.248 nm to 0.276 nm. The water flux of optimized membrane was doubled compared to the control membrane. Most important, the optimized exhibited higher rejection of divalent Na2SO4 (from 98.07% to 99.43%), and meanwhile lower rejection of monovalent NaCl (from 54.07% to 27.52%). NaCl/Na2SO4 separation factor reached up to 130.53, which was about four times of TFC-0 membrane.

Effect of synthesis conditions on the non-uniformity of nanofiltration membrane pore size distribution

Rigorous Determination of Pore Size Non-Uniformity for Nanofiltration Membranes by Incorporating the Effects on Mass Transport

Tailoring Pore Size of Positively-Charged Nanofiltration Membrane Via a Facile Self-Assembly Method

High flux positively charged nanofiltration membranes prepared by UV-initiated graft polymerization of methacrylatoethyl trimethyl ammonium chloride (DMC) onto polysulfone membranes

Preparation and Characterization of Low-Pressure Nanofiltration Membranes and the Application in the Separation Process of Dye Molecules

A NOVEL NANOFILTRATION MEMBRANE PREPARED WITH PAMAM AND TMC (I)

Tuning the nano-porosity and nano-morphology of nano-filtration (NF) membranes: Divalent metal nitrates modulated inter-facial polymerization

Tailoring the pore size distribution of nanofiltration membranes via surfactants with different alkyl chain lengths: Towards efficient molecular separation

Pore Size Tailoring from Ultrafiltration to Nanofiltration with PVC-g-PDMA Via Rapid Immersion Thermal Annealing

Influences of temperature on the retention of PPCPs by nanofiltration membranes: Experiments and modeling assessment

Revealing effect of heat transfer mode on the transformation of microstructure and properties of the nanofiltration membrane

Molecular Design of the Polyamide Layer Structure of Nanofiltration Membranes by Sacrificing Hydrolyzable Groups Toward Enhanced Separation Performance.

Preparation of highly selective nanofiltration membranes by moderately increasing pore size and optimizing microstructure of polyamide layer

Morphologies and separation characteristics of polyphenylsulfone-based solvent resistant nanofiltration membranes: Effect of polymer concentration in casting solution and membrane pretreatment condition

Tailored design of nanofiltration membranes for water treatment based on synthesis-property-performance relationships

Electrosprayed polyamide nanofiltration membrane with uniform and tunable pores for sub-nm precision molecule separation

Nanofiltration Membranes with Narrow Pore Size Distribution Via Contra-Diffusion-Induced Mussel-Inspired Chemistry

Effect of Varying Piperazine Concentration and Post-Modification on Prepared Nanofiltration Membranes in Selectively Rejecting Organic Micropollutants and Salts

Nanofiltration Understanding: A Separation Process of Molecular-Level with Nano-Scale Effect

Can the NF membrane directly obtained by the interfacial polymerization of MPD and TMC?

Synthesizing high performance robust PSf loose nanofiltration membranes through nanobubble-assisted pore-forming