Abstract:The quest to increase the performance of rail car in terms of stability, safety and ride comfort has triggered research into the design, modelling and dynamic simulation of the suspension system of a rail car. Advance control and automation techniques can be used to optimize the performance of a rail car suspension system. This work introduces the mathematical model of two-degree-of-freedom and the use of the conventional proportional integral as well as derivative (PID) controller for the active suspension system of a rail car. Dynamic simulation via the use of MATLAB Simulink environment was employed for the design and analysis of the effect of the controller with the control algorithm of PID controller used to reduce motion of rail car body and the damper. The dynamic model for the linear rail car suspension system was formulated while the PID controller type was used to test the system’s performance while the Ziegler–Nichols tuning rules were used to determine proportional gain, reset rate and derivative time of PID controllers. The results obtained show that the developed controller is highly efficient. The simulated results of the comparison between the passive suspension system and the active suspension system proved that, active suspension system with PID control improves ride comfort, gives lower or almost no peak over shoot (amplitude) and faster settling time compared to the passive suspension system. This enhances safety, good comfort for drivers and passengers as well as isolation of railcar from noise, vibration and other disturbances.

Study on Control Technology of Active Suspension Based on ADAMS and MATLAB

Coordinate Control of Vehicle Semi-Active Suspension Based on Adams/Car and Matlab/Simulink

Active Disturbance Rejection Control for Active Suspension System of Nonlinear Full Car

A Study on the Order Reduction of Vehicle Active Suspension Controller by Using Minimum Information Loss Method

Active Control of Vehicle Suspension Systems Based on Modal Decomposition Method

Study on the coordination control of active suspension employing linear motor based on co-simulation

A Study on the Modified Skyhook Control of the Suspension System in Multi-Axial Heavy Truck

Design and simulation of a controller for an active suspension system of a rail car

Design of Active Suspension Controller Based on Stochastic Linear Optimal Control Theory

Using a PID controller to design an active suspension system in a car

Modelling and Simulation Study on Application of Sliding-Mode Control for an Active Anti-Roll System in A Passenger Car with Air Suspension

Vibration Control Based on Vehicle's Semi-active Suspension by Fuzzy-PID Algorithm

A Study On A Intelligent Controller For Vibration Control Of Semi-Active Suspension System

Study on the Ride Performance of a Semi-Active Air Suspension Vehicle under Complex Models Based on Co-Simulation

Bandwidth-limited active suspension controller for an off-road vehicle based on co-simulation technology

Research on Vehicle Damping Control Strategy Based on In-Arm Torsional Electromagnetic Active Suspension

Modeling, Simulation and Control of Semi Active Suspension System for Automobiles under MATLAB Simulink using PID Controller

Integrated Design for Steering System and Suspension

Comparison of Two Suspension Control Strategies for Multi-Axle Heavy Truck

Modeling and Control of Active Suspensions for MDOF Vehicle

Design and Simulation of a Feedback Controller for an Active Suspension System: A Simplified Approach