Abstract:High contrast imaging can use pupil apodizers to suppress diffracted starlight from a bright source in order to observe its environs. Metallic half-tone dot transmissive apodizers were developed for the Gemini Planet Imager (GPI) and ESO SPHERE coronagraphs for use in the near-IR. Dot sizes on the scale of the wavelength of the light often result in unexpected variations in the optical transmission vs. superficial dot density relation. We measured 5 and 10 micron half-tone microdot screens' transmissions between 550 - 1050 nm to prepare to fabricate apodizations that mitigate diffraction by segments gaps and spiders on future large space telescopes. We utilized slow test beams (f/40, f/80) to estimate the on-axis (far-field, or zero-order) transmission of test patches using a Fourier Transform Spectrograph on Beamline U10B at Brookhaven National Laboratory's National Synchrotron Light Source (BNL NSLS). We also modified our previous GPI IR characterization hardware and methods for this experiment. Our measurements show an internal consistency of 0.1% in transmission, a factor of 5 better than our near-IR GPI work on the NSLS U4IR beamline. The systematics of the set-up appeared to limit the absolute calibration for our f/40 data on the 50-patch, maximum Optical Density 3 (OD3), sample. Credible measurements of transmissions down to about 3% transmission were achieved for this sample. Future work on apodizers for obstructed and segmented primary mirror coronagraphs will require configurations that mimic the intended diffractive configurations closely in order to tune apodizer fabrication to any particular application, and measure chromatic effects in representative diffractive regimes. Further experimental refinements are needed to measure the densest test patches which possess transmissions less than a few percent. The new NSLS-II should provide much greater spectral stability of its synchrotron beam, which will improve measurement accuracy and reduce systematics.

Dynamic Aperture Studies for SPEAR 3

Research on the Design of Kepler Refractive Shaping System with the Long Working Focal Depth

The SPEAR Instrument and On-Orbit Performance

Advanced storage ring lattice options based on hybrid six-bend achromat for Stanford Synchrotron Radiation Lightsource upgrade

Calibrating Apodizer Fabrication Techniques For High-Contrast Coronagraphs On Segmented And Monolithic Space Telescopes

Beam Dynamics Framework Incorporating Acceleration to Define the Minimum Aperture in Two Focusing Schemes for Proton Radiotherapy Linac

Comparison of different longitudinal injection scenarios for achieving optimal performance in SAPS

Upgrades of beam diagnostics in support of emittance-exchange experiments at the Fermilab A0 photoinjector

Dynamic loading platforms coupled to ultra-high speed X-ray imaging at beamline ID19 of the European Synchrotron ESRF

Dynamic Airy Imaging Through High-Efficiency Broadband Phase Microelements by Femtosecond Laser Direct Writing

Mechanical Design and Analysis of the Proposed APEX2 VHF CW Electron Gun

Circular polarization control for the European XFEL in the soft X-ray regime

Development of a full aperture backscatter system for the Orion laser

Studies of Particle Acceleration by an Active Microwave Medium

Dynamic Optics for 3D Laser Material Processing

Optimizing Coded-Apertures for Depth-Resolved Diffraction

Design Study of APSU Type Hybrid MBA Lattice for Mid Energy DLSR

Efficient algorithms for dynamic aperture and momentum acceptance calculation in synchrotron light sources

Three-dimensional, time-dependent simulation of tapered EUV FELs with phase shifters