Abstract:Damage simulation of anchoring structure model and damage simulation diagram in the coupled environment. To investigate the real anchorage performance of basalt and glass hybrid fiber reinforced plastic (FRP) anchors in external corrosive environments. In this paper, a combination of experimental studies and finite element analysis was used. By carrying out pull‐out tests of basalt and glass hybrid FRP anchors under the synergistic effect of freeze–thaw cycles and alkaline environment, the effects of factors such as hole diameter, anchorage length, and mortar strength on their anchorage performance and durability were investigated. Critical corrosion time was introduced to determine the degree of corrosion of the anchor rods. After that, it combined with numerical simulation to reveal the degradation mechanism of the anchorage performance of hybrid anchors. The results showed that the best anchorage performance of basalt/glass hybrid FRP anchors was achieved when the hole diameter was 24 mm, the anchorage length was 175 mm, and the mortar strength was 45.5 MPa. The ultimate pull‐out load was up to 122.16 kN. When the time did not exceed the critical corrosion time, the ultimate load‐carrying capacity of basalt and glass hybrid FRP anchors increased by 9.3% compared to the uncorroded environment. Beyond the critical corrosion time, the ultimate load‐carrying capacity was reduced by 23.3% and the anchorage performance was degraded. In addition, the contact interface between the anchor and the mortar is the weak area of the anchoring structure, which should be focused on in the later design of the actual project. Highlights Basalt/glass hybrid FRP anchors have good corrosion resistance. The anchoring performance of hybrid FRP anchors under the coupled environment is studied. Hole diameter and anchoring length have more influence on the anchor performance. The concept of critical corrosion time is put forward. The failure mechanism and coupling environment influence are revealed by FES.

Development of Post-installed Headed Bars Embedded into Grouted Holes with Enlarged Ends

Dynamic Installation Behaviors of A New Hybrid Plate Anchor in Layered Marine Clay

Behaviour and in Situ Tests of Self-Drilling Prestressed Anchors

Behaviors and application of self-drilling pre-stressed anchors

EXPERIMENT ON CHEMICAL ATTACHMENT OF ANCHOR DEFORM DEPTH 110 MM CAST-IN PLACE AND POST-INSTALLED DRILL BIT EXTRACTOR METHOD

Pullout behavior of the steel-FRP composite bar with the anchor head made of the grout-filled steel tube

Design Recommendations for Concrete Pryout Capacity of Headed Steel Studs and Post-Installed Anchors

Analysis of bond behavior of injected anchors in masonry elements by means of Finite Element Modeling

Pull-Out Performance of Anchored Carbon-Fiber Bundles in Cementitious Matrix

Investigation of the Tensile Properties of High-Strength Bolted Joints in Static Drill Rooted Nodular Piles

Experimental study on a novel UHPC grout-filled pipe sleeve with mechanical interlocking for large-diameter deformed bars

Anchorage Performance of Geopolymer-Grouted Rock Bolts

Experimental Testing of Grouted Posttensioned Anchors with High Rod-to-Duct Area Ratios

Field and Laboratory Investigation of Pullout Resistance of Steel Anchors in Rock

Development and Mechanical Property Analysis of a Novel Uplift Pile Incorporating Composite Anchors

Study on the anchoring performance and failure mechanism of basalt/glass hybrid fiber reinforced plastic anchors in coupled environment

EKSPERIMEN KEGAGALAN BREAKOUT CHEMICAL ANCHOR STUD METODE CAST IN PLACE DAN POST INSTALLED DENGAN MODIFIKASI LUBANG DRILL BIT EXTRACTOR

Mechanical behavior of grouted sleeve connection for rebars in precast concrete structures and reliability analysis considering the ratio of anchorage length to rebar diameter

Tensile Performance of Headed Anchors in Steel Fiber Reinforced and Conventional Concrete in Uncracked and Cracked State

Anchorage failure mechanism and uplift bearing capacity of L- & J-anchor bolts in plain concrete

Performance Assessment of the Post-Tensioned Anchorage Zone Using High-Strength Concrete Considering Confinement Effect