Abstract:It is significant to conduct anchorage on the non-persistent jointed rock mass by bolts to inhabit the unstable fracture evolution of rock engineering. In this research, a series of experiments are done on 70 specimens to investigate the effect of anchorage method on strength and deformation behavior of a non-persistent jointed rock mass. First, based on the stress–strain curves of anchorage jointed specimens, the effect of anchorage method on the peak strength and elastic modulus of non-persistent jointed rock mass is investigated. The experimental results show that the peak strength and elastic modulus of jointed specimens changes with anchorage method for the same joint angle, while first decreases and then increases from 0° to 90° for the same anchorage method. Second, the effect of pretightening force on the strength and deformation behavior of anchorage jointed specimens is analyzed. The axial stress-axial strain curves of anchorage jointed specimens with various pretightening forces can be characterized into five types: (I) strain softening after the specimen drops to yield platform from peak strength; (II) strain hardening after the specimen drops to yield platform from peak strength; (III) strain hardening after the specimen yields; (IV) stepwise strain softening after the peak strength; (V) single stress drop after the peak strength. The peak strength and elastic modulus of jointed specimens for the same dip angle all increases nonlinearly with the pretightening force. And then, based on a series of surface failure mode of non-persistent jointed rock specimen, it can be seen that the initiation, propagation and coalescence of surface cracks depend on not only the joint angle, but also the magnitude of pretightening force. Twelve crack coalescence types are identified to analyze the surface crack mode of anchorage non-persistent jointed rock specimens. Finally, the effect of pretightening force on brittleness index of non-persistent jointed rock mass is made a discussion.

Experimental Testing of Grouted Posttensioned Anchors with High Rod-to-Duct Area Ratios

Cyclic Testing Of Moment Connections Upgraded With Weld Overlays

The Installation Behavior and Capacity of Piggy-Backed Anchors for Offshore Wind Turbine

Estimating the remaining service life of in-situ grouted post-tension anchors using flaw tolerance limit plots

Experimental and Numerical Study of Corrugated Anchors for CFRP Plates

Experimental Study on Grouting Mortar GFRP Anchor Rod Pulling Test

Experiment Program on Retrofitted Anchorage System under Impact Loads

Effect of anchorages on C-FRCM/concrete interfacial shear performance

Study on the Performance of Full-Length Pre-Stressed Anchor Bolts

Bond and re‐anchoring tests of post‐tensioned steel tendon in case of strand failure inside cement grouting with voids

Experimental Study on Anchorage Mechanical Behavior and Surface Cracking Characteristics of a Non-persistent Jointed Rock Mass

Experimental Research on Bonded Anchorage of Carbon Fiber Reinforced Polymer Prestressed Strands

In-Situ Test and Numerical Simulation of Anchoring Performance of Embedded Rock GFRP Anchor

The Model Test on the Anchoring Performance of GFRP Anti-Floating Anchor with Base Floor

Field test of GFRP bar anti-floating anchor slurry-rock interface bonding performance

Experimental investigation and damage evaluation of a novel bond type anchorage for carbon fiber reinforced polymer tendons

Influence of the Anchor Fan Position on the Performance of FRP Anchors

The Behavior of Post-installed Rebar Connectors in Steel Frame Retrofitted Concrete Structures Under Combined Shear and Tension

Experimental Evaluation of Strut-and-Tie Model of Anchorage Zone in Posttensioned Concrete Structures

Field and Laboratory Investigation of Pullout Resistance of Steel Anchors in Rock

Experimental investigation and analytical prediction on bond behaviour of CFRP-to-concrete interface with FRP anchors