Abstract:International Journal of Damage Mechanics, Ahead of Print. Pre-stressed anchor bolts serve as an effective means to reinforce fractured rock masses. The long-term efficacy of their anchoring function significantly impacts the safety throughout the entire lifecycle of rock engineering projects. Over time, fractured rock masses undergo creep deformation, which interacts synergistically with the time-dependent changes in the pre-stress of anchor bolts. In this work, we conduct uniaxial tensile tests and tensile creep tests on fractured rock specimens anchored by pre-stressed bolts, analyzing the coordinated deformation between the pre-stressed anchor bolts and the fractured specimens. Firstly, conventional uniaxial tensile tests were conducted on the pre-stressed anchorage specimen. The study found that the tensile strength of the anchored specimens was significantly higher than that of the unanchored specimens. Additionally, the ability of the specimens to withstand tensile stresses and deformation improved as pre-stress increased. Secondly, uniaxial tensile creep tests were conducted on the prestressed anchored specimens. The results indicate that, as the stress level increases, the creep strain continues to increase. The application of prestress can effectively limit the tensile deformation of the specimen and delay its damage time. The greater the pre-stress, the smaller the instantaneous strain and creep strain rate during the graded loading test. Finally, based on the synergistic deformation of pre-stressed anchor bolts and the creeping rock mass, we establish a constitutive model reflecting the creep properties of fractured rock mass and derive a theoretical viscoelastic creep formula for anchored rock mass under uniaxial tension. Comparing the creep model with the test results shows that this model is highly applicable and accurate in verifying the tensile creep deformation of prestressed anchorage specimens.

Behaviour and in Situ Tests of Self-Drilling Prestressed Anchors

Behaviors and application of self-drilling pre-stressed anchors

Full-Scale Field Test On Retaining Structure Enhanced With Soil Nails And Prestressed Anchors

Performance Tests on Pressure-Dispersed Compression Anchors in Cohesive Soils

Behavoir Of Installation For Suction Anchor In Soft Clay

Element-scale pullout test study on the mechanical behavior of grouted anchor–soil interface subjected to ground pressure

Study on the Performance of Full-Length Pre-Stressed Anchor Bolts

Working Stress Measurement of Prestressed Anchor Cables:Detection Mechanism and Experimental Study of Lift-off Test

Experimental and Data-Driven Prediction for the Impact of Free/bond Lengths of Element Specimen on Interface Characterization of Ground Anchors

In-Situ Test and Numerical Simulation of Anchoring Performance of Embedded Rock GFRP Anchor

Study on Mechanical Response Characteristics of Anchor under Dynamic Disturbance

Three-dimensional Interaction Between Anchor Chain and Seabed

Compression/tension Load Capacity of Stone Column Anchors

Analysis of shear characteristics of prestressed anchor cable and shear resistance of anchor joint plane

Systematic Monitoring of the Performance of Anchor Systems in Fractured Rock Masses

A Model Test on the Behavior of A Static Drill Rooted Nodular Pile under Compression

Field Behavior of Driven Prestressed High-Strength Concrete Piles in Sandy Soils

A Field Study on the Behavior of Static Drill Rooted Nodular Piles with Caps under Compression

Investigation into the time-dependent mechanical behavior of pre-stressed anchor bolts and fractured rock specimens under synchronized tensile loads

EXPERIMENT ON CHEMICAL ATTACHMENT OF ANCHOR DEFORM DEPTH 110 MM CAST-IN PLACE AND POST-INSTALLED DRILL BIT EXTRACTOR METHOD

A test on base bearing capacity of static drill rooted nodular pile