Abstract:With the development of urbanization, numerous underground structures were constructed in composite soil. It is common that the aseismic capacity of the underground structure is influenced by the soil. Hence, during the seismic design, the underground structure located at the composite soil should be noticed. In this study, the seismic response of a frame-type subway station located in composite soil was explored by shaking table tests. The acceleration response, the strain distribution, and the earth-pressure distribution of the model system under the motion of the Kobe wave and the Chongqing artificial wave were obtained and interpreted. The test results demonstrated that the peak acceleration response of the model soil and the model structure increases with the input acceleration and the distance to the shaking table. The acceleration response of the model soil is influenced by the location of the model structure, and the model soil can determine the seismic response of the model structure. The strong strain response of the model structure occurred when the peak accelerations of both input waves were greater than 0.4 g . Under the action of major earthquakes (e.g., PGA = 0.4 g , 0.8 g , and 1.0 g ), the strain at the top of the upper intermediate column and the bottom of the lower intermediate column is significantly greater than that of other components. It is suggested that the ductility of the intermediate columns ought to focus on the seismic design of the frame-type station located in composite soil. The maximum earth-pressure occurs in the middle of the external side wall. The earth-pressure pattern demonstrates a U-type distribution in the X -direction, and the distribution characteristics are more significant as the input peak acceleration increases.

Seismic performance evaluation of water supply pipes installed in a full-scale RC frame structure based on a shaking table test

Seismic Damage Assessment of Urban Water Supply Pipeline

Method and Application of Seismic Reliability Assessment for Urban Water Supply Pipeline

Comparison and Application of Seismic Damage Assessment Method in Urban Water Supply Pipeline

Experimental and Numerical Investigation on the Seismic Behavior of above Ground High Density Polyethylene Pipe in Nuclear Power Plant

Dynamic Response and Vibration Isolation of Pipes Inside a Utility Tunnel Passing Through Nonhomogeneous Soil under Seismic Action

TESTING STUDY AND ANALYSIS ON SOIL DISTURBANCE INDUCED BY PIPE JACKING CONSTRUCTION

HYBRID DYNAMIC RESPONSE TEST FOCUSING ON THE SUPPORT STRUCTURE OF PIPING SYSTEMS

Seismic performance evaluation of an infilled rocking wall frame structure through quasi-static cyclic testing

Numerical Simulation and Experimental Validation of the Seismic Response of Suspended Grooved-Fit Piping Systems

Shaking table test of prestressed high-strength concrete pipe piles reinforced with non-prestressed steel reinforcement

Full-Scale Experimental Study on the Effect of Ground Surcharge on the Stress and Deformation of Shield Tunnels

Seismic Performance Levels of a Large Underground Subway Station in Different Soil Foundations

Seismic resilience evaluation of water distribution systems considering hydraulic and water quality performance

Experimental Study on the Seismic Performance of Seismic Bracing in Important Buildings

Seismic Response of a Water Transmission Pipeline Across a Fault Zone Adopting a Large-Scale Vibration Table Test

Bidirectional Seismic Performance and Design Approach of RC Infill Wall with PVC Tubes

Shaking table test on the seismic performance of prefabricated utility tunnel passing through hard-soft strata under longitudinal excitation

Shaking Table Test on the Seismic Response of a Frame-Type Subway Station in Composite Soil

Shake-table test on dynamic response of prestressed high-strength concrete pipe piles under Soil–Structure interaction

Seismic performance analysis of shallow-buried large-scale three-box-section segment-connected pipeline structure under multiple actions