Abstract:This paper presents the results of centrifuge tests performed on reinforced concrete (RC) pile–supported simply supported girder bridge models in non-liquefiable (unsaturated) and liquefiable (saturated) slightly inclined sandy soil sites. The main objectives were to investigate the dynamic response characteristics of RC pile–supported simply supported girder bridges in non-liquefiable and liquefiable soils, examine the mechanisms causing beam collapse and damage to pile–pier yielding, and verify the effectiveness of cable restrainers. The centrifuge tests were conducted in non-liquefiable and liquefiable sites, each consisting of a three-span RC pile–supported simply supported girder bridge model and a control model with a superstructure equipped with a cable restrainer. First, the dynamic characteristic parameters of the soil and structural models in both sites were obtained. Subsequently, the conventional test results were interpreted, including the excess pore pressure ratio, acceleration, and displacement. The analysis included examining the moment demand of the pile–pier structure and seismic damage mechanisms. Finally, a correlation analysis was performed to evaluate the inertial and kinematic effects on the moment demand of the pile–pier structure. The results show that the acceleration response after soil liquefaction at the inclined sites is amplified unilaterally in the downslope direction and spikes appear. The liquefiable foundation is displaced to the downslope. However, major earthquake induces foundation displacement, and liquefaction leads to a longer duration and more significant soil displacement. The installation of cable restraints significantly increased the acceleration response of the superstructure. Still, it effectively reduced the relative displacement of the superstructure and prevented the beam from collapsing. Soil liquefaction decreases the bending moment of the pile–pier structure, and the cable restrainer causes the damage mode of the pile–pier structure to shift from the pile head to the pier bottom. In the non-liquefiable scenario, the bending moment demand at the pile head has a more significant influence on the inertial effect. Additionally, using the cable restrainer system can increase the kinematic effect after liquefaction. The test results can be used to validate numerical models and provide a reference for pile foundation design.

Shake-table test on dynamic response of prestressed high-strength concrete pipe piles under Soil–Structure interaction

Statistical research on performance of prestressed concrete pipe piles

Influence of Weld on Integrity Testing of Prestressed Pipe Piles

Shaking table test of prestressed high-strength concrete pipe piles reinforced with non-prestressed steel reinforcement

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Field Behavior of Pre-Stressed High-Strength Concrete Nodular Piles and PHC Pipe Piles Under Compression in Soft Soil Areas

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

Field Behavior of Driven Prestressed High-Strength Concrete Piles in Sandy Soils

Dynamic Response Analysis of Pile Group Foundation of Super-Giant Sewage Treatment Structure on Hydraulic Fill Foundation

Influence of Soil Reinforcement on the Uplift Bearing Capacity of a Pre-Stressed High-Strength Concrete Pile Embedded in Clayey Soil

Field test of earth pressure at pile-soil interface by single pile penetration in silty soil and silty clay

Theoretical study of dynamic pore water pressure dissipation characteristics of open-hole pipe pile

Shaking Table Test and Numerical Simulation Study on Tunnel-Soil-Bridge Pile Structure Interaction System

Evaluation of Ultimate Bearing Capacity of Pre-Stressed High-Strength Concrete Pipe Pile Embedded in Saturated Sandy Soil Based on In-Situ Test

Dynamic Soil Reactions Around a Beam-on-Multiple-Piles Structure and Their Application in the Parallel Seismic Integrity Test

Field Test of Excess Pore Water Pressure at Pile–Soil Interface Caused by PHC Pipe Pile Penetration Based on Silicon Piezoresistive Sensor

Comparative Study on Shaking Table Tests for a Pile–Nuclear Island Structure under Different Soil Conditions

Real-time Dynamic Hybrid Testing for Soil–structure Interaction Analysis

Experimental study on seismic performance of prestressed concrete solid square piles

Kinematic response of pipe pile embedded in fractional-order viscoelastic unsaturated soil subjected to vertically propagating seismic SH-waves

Experimental investigation of dynamic behaviour of pile-supported bridges in sandy deposits