Particle-wall heat transfer in narrow-channel bubbling fluidized beds for thermal energy storage

Keaton J. Brewster,Jesse R. Fosheim,Winfred J. Arthur-Arhin,Katherine E. Schubert,Melodie Chen-Glasser,Julia E. Billman,Gregory S. Jackson

DOI: https://doi.org/10.1016/j.ijheatmasstransfer.2024.125276

IF: 5.2

2024-02-11

International Journal of Heat and Mass Transfer

Abstract:Robust metal oxide particles can provide low-cost and stable thermal energy storage (TES) to temperatures up to 1200 ∘ C or higher. The transfer of heat into and out of the particles in cost-effective high-temperature particle heat exchangers remains a principal challenge to implementing particle-based TES. The present work expands on prior studies of particle-wall heat transfer in narrow-channel fluidized beds operated in the bubbling fluidization regime. Batch-mode experiments with various oxide particles over a range of temperatures and airflow rates indicate that particle-wall heat transfer increases with higher bed temperature and decreasing particle size. Measured particle-wall heat transfer coefficients in a 12 mm deep channel are fit to a Nusselt number correlation proportional to a non-monotonic function of excess fluidization velocity. Particle-wall heat transfer coefficients rise rapidly with excess fluidization velocities until reaching a maximum at intermediate air velocities due to a trade-off between enhanced transverse particle mixing and decreasing particle volume fraction with increased fluidization velocity. The heat transfer coefficient reaches a maximum of ≈400% of values without fluidization for oxide particles ranging in diameter dp from 159 to 408 μm. For the smallest particles tested, composed of olivine sand, particle-wall heat transfer coefficients peak above 1100 W m −2 K −1 at 450 ∘ C. 100-h tests at 500 ∘ C and near-optimal heat transfer fluidization velocities indicated minimal wall wear or oxide scaling. High particle-wall heat transfer coefficients suggest narrow channel fluidized beds as a potential pathway for reducing the required surface area and cost of high-temperature particle heat exchangers, as needed in large-scale thermal energy storage applications.

engineering, mechanical,thermodynamics,mechanics